and it will start doing what the job_file tells it to do. You can give
more than one job file on the command line, fio will serialize the running
of those files. Internally that is the same as using the 'stonewall'
-parameter described the the parameter section.
+parameter described in the parameter section.
If the job file contains only one job, you may as well just give the
parameters on the command line. The command line parameters are identical
Unless specific nrfiles and filesize options are given,
fio will divide this size between the available files
specified by the job. If not set, fio will use the full
- size of the given files or devices. If the the files
- do not exist, size must be given. It is also possible to
- give size as a percentage between 1 and 100. If size=20%
- is given, fio will use 20% of the full size of the given
+ size of the given files or devices. If the files do not
+ exist, size must be given. It is also possible to give
+ size as a percentage between 1 and 100. If size=20% is
+ given, fio will use 20% of the full size of the given
files or devices.
io_limit=int Normally fio operates within the region set by 'size', which
specified period of time, reducing the resolution of the log.
Defaults to 0.
+log_offset=int If this is set, the iolog options will include the byte
+ offset for the IO entry as well as the other data values.
+
lockmem=int Pin down the specified amount of memory with mlock(2). Can
potentially be used instead of removing memory or booting
with less memory to simulate a smaller amount of memory.