+ IO latencies microseconds: <=2, 4, 10, 20, 50, 100, 250, 500, 750, 1000
+ IO latencies milliseconds: <=2, 4, 10, 20, 50, 100, 250, 500, 750, 1000, 2000, >=2000
+ Disk utilization: Disk name, Read ios, write ios,
+ Read merges, write merges,
+ Read ticks, write ticks,
+ Time spent in queue, disk utilization percentage
+ Additional Info (dependant on continue_on_error, default off): total # errors, first error code
+
+ Additional Info (dependant on description being set): Text description
+
+Completion latency percentiles can be a grouping of up to 20 sets, so
+for the terse output fio writes all of them. Each field will look like this:
+
+ 1.00%=6112
+
+which is the Xth percentile, and the usec latency associated with it.
+
+For disk utilization, all disks used by fio are shown. So for each disk
+there will be a disk utilization section.
+
+
+8.0 Trace file format
+---------------------
+There are two trace file format that you can encounter. The older (v1) format
+is unsupported since version 1.20-rc3 (March 2008). It will still be described
+below in case that you get an old trace and want to understand it.
+
+In any case the trace is a simple text file with a single action per line.
+
+
+8.1 Trace file format v1
+------------------------
+Each line represents a single io action in the following format:
+
+rw, offset, length
+
+where rw=0/1 for read/write, and the offset and length entries being in bytes.
+
+This format is not supported in Fio versions => 1.20-rc3.
+
+
+8.2 Trace file format v2
+------------------------
+The second version of the trace file format was added in Fio version 1.17.
+It allows to access more then one file per trace and has a bigger set of
+possible file actions.
+
+The first line of the trace file has to be:
+
+fio version 2 iolog
+
+Following this can be lines in two different formats, which are described below.
+
+The file management format:
+
+filename action
+
+The filename is given as an absolute path. The action can be one of these:
+
+add Add the given filename to the trace
+open Open the file with the given filename. The filename has to have
+ been added with the add action before.
+close Close the file with the given filename. The file has to have been
+ opened before.
+
+
+The file io action format:
+
+filename action offset length
+
+The filename is given as an absolute path, and has to have been added and opened
+before it can be used with this format. The offset and length are given in
+bytes. The action can be one of these: