ARM: dts: bcm2835: fix uart0 pinctrl node names

Downstream kernel uses pins 32, 33 as UART0 (PL011) Rx/Tx to communicate with
the Bluetooth chip. So ALT3 of these pins is most likely not CTS/RTS. Change
the node name to reflect that. This matches section 6.2 "Alternative Function
Assignments" in the BCM2835 ARM Peripherals document.

With this change in place, adding

  &uart0 {
	 pinctrl-names = "default";
	 pinctrl-0 = <&uart0_gpio32 &gpclk2_gpio43>;
	 status = "okay";
  };

to bcm2837-rpi-3-b.dts does the right thing on my Raspberry Pi 3.

Pins 30, 31 are CTS/RTS of UART0 in alternate function 3. Rename uart0_gpio30
as well.

While at it, fix a little typo in a nearby comment.

Fixes: 21ff843931b ("ARM: dts: bcm283x: Define standard pinctrl groups in the gpio node.")
Acked-by: Stefan Wahren <stefan.wahren@i2se.com>
Signed-off-by: Baruch Siach <baruch@tkos.co.il>
Reviewed-by: Eric Anholt <eric@anholt.net>

diff --git a/arch/arm/boot/dts/bcm283x.dtsi b/arch/arm/boot/dts/bcm283x.dtsi
index 35cea3fcaf5c479e68e50e5d8e6606cb9735abba..e9623af3ad76a52ac94aab080a8b8cb5eba50597 100644 (file)
--- a/arch/arm/boot/dts/bcm283x.dtsi
+++ b/arch/arm/boot/dts/bcm283x.dtsi
@@ -295,17 +295,17 @@
                        /* Separate from the uart0_gpio14 group
                         * because it conflicts with spi1_gpio16, and
                         * people often run uart0 on the two pins
-                        * without flow contrl.
+                        * without flow control.
                         */
                        uart0_ctsrts_gpio16: uart0_ctsrts_gpio16 {
                                brcm,pins = <16 17>;
                                brcm,function = <BCM2835_FSEL_ALT3>;
                        };
-                       uart0_gpio30: uart0_gpio30 {
+                       uart0_ctsrts_gpio30: uart0_ctsrts_gpio30 {
                                brcm,pins = <30 31>;
                                brcm,function = <BCM2835_FSEL_ALT3>;
                        };
-                       uart0_ctsrts_gpio32: uart0_ctsrts_gpio32 {
+                       uart0_gpio32: uart0_gpio32 {
                                brcm,pins = <32 33>;
                                brcm,function = <BCM2835_FSEL_ALT3>;
                        };