From: Miquel Raynal <miquel.raynal@bootlin.com>
Date: Wed, 23 Mar 2022 17:07:51 +0000 (+0100)
Subject: Merge tag 'nand/for-5.18' into mtd/next
X-Git-Tag: v5.18-rc1~112^2
X-Git-Url: https://git.kernel.dk/?a=commitdiff_plain;h=6cadd424abb63120f8346a4509dc43bddc9401d3;p=linux-block.git

Merge tag 'nand/for-5.18' into mtd/next

Raw NAND core changes:
* Rework of_get_nand_bus_width()
* Remove of_get_nand_on_flash_bbt() wrapper
* Protect access to rawnand devices while in suspend
* bindings: Document the wp-gpios property

Rax NAND controller driver changes:
* atmel: Fix refcount issue in atmel_nand_controller_init
* nandsim:
  - Add NS_PAGE_BYTE_SHIFT macro to replace the repeat pattern
  - Merge repeat codes in ns_switch_state
  - Replace overflow check with kzalloc to single kcalloc
* rockchip: Fix platform_get_irq.cocci warning
* stm32_fmc2: Add NAND Write Protect support
* pl353: Set the nand chip node as the flash node
* brcmnand: Fix sparse warnings in bcma_nand
* omap_elm: Remove redundant variable 'errors'
* gpmi:
  - Support fast edo timings for mx28
  - Validate controller clock rate
  - Fix controller timings setting
* brcmnand:
  - Add BCMA shim
  - BCMA controller uses command shift of 0
  - Allow platform data instantation
  - Add platform data structure for BCMA
  - Allow working without interrupts
  - Move OF operations out of brcmnand_init_cs()
  - Avoid pdev in brcmnand_init_cs()
  - Allow SoC to provide I/O operations
  - Assign soc as early as possible

Onenand changes:
* Check for error irq

Signed-off-by: Miquel Raynal <miquel.raynal@bootlin.com>
---

6cadd424abb63120f8346a4509dc43bddc9401d3
diff --cc Documentation/devicetree/bindings/mtd/nand-controller.yaml
index 33855eb48a79,53b21aed0ac5..359a015d4e5a
--- a/Documentation/devicetree/bindings/mtd/nand-controller.yaml
+++ b/Documentation/devicetree/bindings/mtd/nand-controller.yaml
@@@ -116,6 -154,20 +116,13 @@@ patternProperties
            Ready/Busy pins. Active state refers to the NAND ready state and
            should be set to GPIOD_ACTIVE_HIGH unless the signal is inverted.
  
+       wp-gpios:
+         description:
+           Contains one GPIO descriptor for the Write Protect pin.
+           Active state refers to the NAND Write Protect state and should be
+           set to GPIOD_ACTIVE_LOW unless the signal is inverted.
+         maxItems: 1
+ 
 -      secure-regions:
 -        $ref: /schemas/types.yaml#/definitions/uint64-matrix
 -        description:
 -          Regions in the NAND chip which are protected using a secure element
 -          like Trustzone. This property contains the start address and size of
 -          the secure regions present.
 -
      required:
        - reg