From: Florian Fainelli Date: Fri, 13 Dec 2019 19:51:02 +0000 (-0800) Subject: ARM: dts: NSP: Use hardware I2C for BCM958625HR X-Git-Tag: v5.6-rc1~19^2~10^2~3 X-Git-Url: https://git.kernel.dk/?a=commitdiff_plain;h=030cc6cb1b6ccc09b74a7957958559dee00ec038;p=linux-block.git ARM: dts: NSP: Use hardware I2C for BCM958625HR Now that the i2c-bcm-iproc driver has been fixed to permit reading more than 63 bytes in a single transaction with commit fd01eecdf959 ("i2c: iproc: Fix i2c master read more than 63 bytes") we no longer need to bitbang i2c over GPIOs which was necessary before to allow the PHYLINK/SFP subsystems to read SFP modules. Reviewed-by: Ray Jui Signed-off-by: Florian Fainelli --- diff --git a/arch/arm/boot/dts/bcm958625hr.dts b/arch/arm/boot/dts/bcm958625hr.dts index a2c9de35ddfb..536fb24f38bb 100644 --- a/arch/arm/boot/dts/bcm958625hr.dts +++ b/arch/arm/boot/dts/bcm958625hr.dts @@ -55,18 +55,9 @@ priority = <200>; }; - /* Hardware I2C block cannot do more than 63 bytes per transfer, - * which would prevent reading from a SFP's EEPROM (256 byte). - */ - i2c1: i2c { - compatible = "i2c-gpio"; - sda-gpios = <&gpioa 5 (GPIO_ACTIVE_HIGH | GPIO_OPEN_DRAIN)>; - scl-gpios = <&gpioa 4 (GPIO_ACTIVE_HIGH | GPIO_OPEN_DRAIN)>; - }; - sfp: sfp { compatible = "sff,sfp"; - i2c-bus = <&i2c1>; + i2c-bus = <&i2c0>; mod-def0-gpios = <&gpioa 28 GPIO_ACTIVE_LOW>; los-gpios = <&gpioa 24 GPIO_ACTIVE_HIGH>; tx-fault-gpios = <&gpioa 30 GPIO_ACTIVE_HIGH>; @@ -74,6 +65,10 @@ }; }; +&i2c0 { + status = "okay"; +}; + &amac0 { status = "okay"; };