iio: humidity: hdc3020: add reset management

The HDC3020 provides an active low reset signal that must be handled if
connected. Asserting this signal turns the device into Trigger-on Demand
measurement mode, reducing its power consumption when no measurements
are required like in low-power modes.

According to the datasheet, the longest "Reset Ready" is 3 ms, which is
only taken into account if the reset signal is defined.

Signed-off-by: Javier Carrasco <javier.carrasco.cruz@gmail.com>
Link: https://lore.kernel.org/r/20240303-hdc3020-pm-v3-3-48bc02b5241b@gmail.com
Signed-off-by: Jonathan Cameron <Jonathan.Cameron@huawei.com>

diff --git a/drivers/iio/humidity/hdc3020.c b/drivers/iio/humidity/hdc3020.c
index 7f93024b850c2076f4f796524e5b89103c3dc0d9..cdc4789213ba70f2f2ee0e585cb4f5b1180c2ae9 100644 (file)
--- a/drivers/iio/humidity/hdc3020.c
+++ b/drivers/iio/humidity/hdc3020.c
@@ -15,6 +15,7 @@
 #include <linux/cleanup.h>
 #include <linux/crc8.h>
 #include <linux/delay.h>
+#include <linux/gpio/consumer.h>
 #include <linux/i2c.h>
 #include <linux/init.h>
 #include <linux/interrupt.h>
@@ -70,6 +71,7 @@
 
 struct hdc3020_data {
        struct i2c_client *client;
+       struct gpio_desc *reset_gpio;
        struct regulator *vdd_supply;
        /*
         * Ensure that the sensor configuration (currently only heater is
@@ -558,6 +560,9 @@ static int hdc3020_power_off(struct hdc3020_data *data)
 {
        hdc3020_exec_cmd(data, HDC3020_EXIT_AUTO);
 
+       if (data->reset_gpio)
+               gpiod_set_value_cansleep(data->reset_gpio, 1);
+
        return regulator_disable(data->vdd_supply);
 }
 
@@ -571,6 +576,11 @@ static int hdc3020_power_on(struct hdc3020_data *data)
 
        fsleep(5000);
 
+       if (data->reset_gpio) {
+               gpiod_set_value_cansleep(data->reset_gpio, 0);
+               fsleep(3000);
+       }
+
        if (data->client->irq) {
                /*
                 * The alert output is activated by default upon power up,
@@ -627,6 +637,12 @@ static int hdc3020_probe(struct i2c_client *client)
                return dev_err_probe(&client->dev, PTR_ERR(data->vdd_supply),
                                     "Unable to get VDD regulator\n");
 
+       data->reset_gpio = devm_gpiod_get_optional(&client->dev, "reset",
+                                                  GPIOD_OUT_HIGH);
+       if (IS_ERR(data->reset_gpio))
+               return dev_err_probe(&client->dev, PTR_ERR(data->reset_gpio),
+                                    "Cannot get reset GPIO\n");
+
        ret = hdc3020_power_on(data);
        if (ret)
                return dev_err_probe(&client->dev, ret, "Power on failed\n");