It is preferred to use typed property access functions (i.e.
of_property_read_<type> functions) rather than low-level
of_get_property/of_find_property functions for reading properties.
Convert reading boolean properties to of_property_read_bool().
Reviewed-by: Simon Horman <simon.horman@corigine.com>
Reviewed-by: Krzysztof Kozlowski <krzysztof.kozlowski@linaro.org>
Signed-off-by: Rob Herring <robh@kernel.org>
Signed-off-by: David S. Miller <davem@davemloft.net>
return ret;
}
- if (of_find_property(node, "i2c-int-falling", NULL))
+ if (of_property_read_bool(node, "i2c-int-falling"))
pdata->irq_polarity = IRQF_TRIGGER_FALLING;
else
pdata->irq_polarity = IRQF_TRIGGER_RISING;
return reset_n_io;
}
pdata->reset_n_io = reset_n_io;
-
- if (of_find_property(node, "hci-muxed", NULL))
- pdata->hci_muxed = 1;
- else
- pdata->hci_muxed = 0;
+ pdata->hci_muxed = of_property_read_bool(node, "hci-muxed");
return 0;
}
/* GPIO that is wired to RESET_N signal */
int reset_n_io;
/* Tell if transport is muxed in HCI one */
- unsigned int hci_muxed;
+ bool hci_muxed;
/*
* UART specific
*/
/* Tell if UART needs flow control at init */
- unsigned int flow_control;
+ bool flow_control;
/* Tell if firmware supports break control for power management */
- unsigned int break_control;
+ bool break_control;
/*
return ret;
}
- if (of_find_property(matched_node, "flow-control", NULL))
- pdata->flow_control = 1;
- else
- pdata->flow_control = 0;
-
- if (of_find_property(matched_node, "break-control", NULL))
- pdata->break_control = 1;
- else
- pdata->break_control = 0;
+ pdata->flow_control = of_property_read_bool(matched_node, "flow-control");
+ pdata->break_control = of_property_read_bool(matched_node, "break-control");
of_node_put(matched_node);