arm,trig-in-sigs = <0 1>;
arm,trig-in-types = <PE_DBGTRIGGER
PE_PMUIRQ>;
- arm,trig-out-sigs=<0 1 2 >;
+ arm,trig-out-sigs = <0 1 2 >;
arm,trig-out-types = <PE_EDBGREQ
PE_DBGRESTART
PE_CTIIRQ>;
trig-conns@0 {
reg = <0>;
- arm,trig-in-sigs=<0>;
- arm,trig-in-types=<GEN_INTREQ>;
- arm,trig-out-sigs=<0>;
- arm,trig-out-types=<GEN_HALTREQ>;
+ arm,trig-in-sigs = <0>;
+ arm,trig-in-types = <GEN_INTREQ>;
+ arm,trig-out-sigs = <0>;
+ arm,trig-out-types = <GEN_HALTREQ>;
arm,trig-conn-name = "sys_profiler";
};
trig-conns@1 {
reg = <1>;
- arm,trig-out-sigs=<2 3>;
- arm,trig-out-types=<GEN_HALTREQ GEN_RESTARTREQ>;
+ arm,trig-out-sigs = <2 3>;
+ arm,trig-out-types = <GEN_HALTREQ GEN_RESTARTREQ>;
arm,trig-conn-name = "watchdog";
};
trig-conns@2 {
reg = <2>;
- arm,trig-in-sigs=<1 6>;
- arm,trig-in-types=<GEN_HALTREQ GEN_RESTARTREQ>;
+ arm,trig-in-sigs = <1 6>;
+ arm,trig-in-types = <GEN_HALTREQ GEN_RESTARTREQ>;
arm,trig-conn-name = "g_counter";
};
};
compatible = "ti,k2g-sci";
ti,system-reboot-controller;
mbox-names = "rx", "tx";
- mboxes= <&msgmgr 5 2>,
- <&msgmgr 0 0>;
+ mboxes = <&msgmgr 5 2>,
+ <&msgmgr 0 0>;
reg-names = "debug_messages";
reg = <0x02921800 0x800>;
};
compatible = "ti,k2g-sci";
ti,host-id = <12>;
mbox-names = "rx", "tx";
- mboxes= <&secure_proxy_main 11>,
- <&secure_proxy_main 13>;
+ mboxes = <&secure_proxy_main 11>,
+ <&secure_proxy_main 13>;
reg-names = "debug_messages";
reg = <0x44083000 0x1000>;
#include <dt-bindings/interrupt-controller/arm-gic.h>
gmu: gmu@506a000 {
- compatible="qcom,adreno-gmu-630.2", "qcom,adreno-gmu";
+ compatible = "qcom,adreno-gmu-630.2", "qcom,adreno-gmu";
reg = <0x506a000 0x30000>,
<0xb280000 0x10000>,
vdd3-supply = <&vcclcd_reg>;
vci-supply = <&vlcd_reg>;
reset-gpios = <&gpy4 5 0>;
- power-on-delay= <50>;
+ power-on-delay = <50>;
reset-delay = <100>;
init-delay = <100>;
panel-width-mm = <58>;
#size-cells = <0>;
vopb_out_edp: endpoint@0 {
reg = <0>;
- remote-endpoint=<&edp_in_vopb>;
+ remote-endpoint = <&edp_in_vopb>;
};
vopb_out_hdmi: endpoint@1 {
reg = <1>;
- remote-endpoint=<&hdmi_in_vopb>;
+ remote-endpoint = <&hdmi_in_vopb>;
};
};
};
examples:
- |
spi {
- #address-cells= <1>;
+ #address-cells = <1>;
#size-cells = <0>;
adc@0 {
cru_parallel_in: endpoint@0 {
reg = <0>;
- remote-endpoint= <&ov5642>;
+ remote-endpoint = <&ov5642>;
hsync-active = <1>;
vsync-active = <1>;
};
cru_csi_in: endpoint@0 {
reg = <0>;
- remote-endpoint= <&csi_cru_in>;
+ remote-endpoint = <&csi_cru_in>;
};
};
};
vin0csi20: endpoint@0 {
reg = <0>;
- remote-endpoint= <&csi20vin0>;
+ remote-endpoint = <&csi20vin0>;
};
vin0csi40: endpoint@2 {
reg = <2>;
- remote-endpoint= <&csi40vin0>;
+ remote-endpoint = <&csi40vin0>;
};
};
};
reg = <0 0xf80000>;
};
firmware@f80000 {
- label ="firmware";
+ label = "firmware";
reg = <0xf80000 0x80000>;
read-only;
};
reg = <0x1101c000 0x1300>;
interrupts = <GIC_SPI 237 IRQ_TYPE_LEVEL_LOW>;
interrupt-names = "macirq";
- phy-mode ="rgmii-rxid";
+ phy-mode = "rgmii-rxid";
mac-address = [00 55 7b b5 7d f7];
clock-names = "axi",
"apb",
- |
#include <dt-bindings/interrupt-controller/arm-gic.h>
pmu {
- #address-cells=<2>;
- #size-cells=<2>;
+ #address-cells = <2>;
+ #size-cells = <2>;
pmu@ff638000 {
compatible = "amlogic,g12a-ddr-pmu";
clocks = <&clk26m>;
clock-output-names = "mipi_tx0_pll";
drive-strength-microamp = <4000>;
- nvmem-cells= <&mipi_tx_calibration>;
+ nvmem-cells = <&mipi_tx_calibration>;
nvmem-cell-names = "calibration-data";
#clock-cells = <0>;
#phy-cells = <0>;
examples:
- |
remoteproc@1c {
- compatible= "amlogic,meson8-ao-arc", "amlogic,meson-mx-ao-arc";
+ compatible = "amlogic,meson8-ao-arc", "amlogic,meson-mx-ao-arc";
reg = <0x1c 0x8>, <0x38 0x8>;
reg-names = "remap", "cpu";
resets = <&media_cpu_reset>;
# Dual role switch with type-c
- |
usb@11201000 {
- compatible ="mediatek,mt8183-mtu3", "mediatek,mtu3";
+ compatible = "mediatek,mt8183-mtu3", "mediatek,mtu3";
reg = <0x11201000 0x2e00>, <0x11203e00 0x0100>;
reg-names = "mac", "ippc";
interrupts = <GIC_SPI 72 IRQ_TYPE_LEVEL_LOW>;
usb@31100000 {
compatible = "snps,dwc3";
- reg =<0x00 0x31100000 0x00 0x50000>;
+ reg = <0x00 0x31100000 0x00 0x50000>;
interrupts = <GIC_SPI 226 IRQ_TYPE_LEVEL_HIGH>, /* irq.0 */
<GIC_SPI 226 IRQ_TYPE_LEVEL_HIGH>; /* irq.0 */
interrupt-names = "host", "peripheral";