USB: ohci-at91 uses generic GPIO calls
authorDavid Brownell <dbrownell@users.sourceforge.net>
Thu, 27 Dec 2007 19:19:49 +0000 (11:19 -0800)
committerGreg Kroah-Hartman <gregkh@suse.de>
Fri, 1 Feb 2008 22:35:01 +0000 (14:35 -0800)
Update the ohci-at91 bus glue to start understanding about the per-port
power switch GPIOs it's given (on the sam9263-ek and potentially other
boards).  For the moment this just claims them and forces them active
(assuming active-low power enables) whenever the HCD is loaded.

The assumption is still that board setup configures the GPIOs.  Using
gpio_request() tracks actual usage and guards against conflict.

Signed-off-by: David Brownell <dbrownell@users.sourceforge.net>
Signed-off-by: Greg Kroah-Hartman <gregkh@suse.de>
drivers/usb/host/ohci-at91.c

index d849c809acbdca97394fa7b8dcd8225733a91f5a..126fcbdd6408a2fed44fec58a0b3c74798200d0e 100644 (file)
@@ -17,6 +17,8 @@
 
 #include <asm/mach-types.h>
 #include <asm/hardware.h>
+#include <asm/gpio.h>
+
 #include <asm/arch/board.h>
 #include <asm/arch/cpu.h>
 
@@ -271,12 +273,41 @@ static const struct hc_driver ohci_at91_hc_driver = {
 
 static int ohci_hcd_at91_drv_probe(struct platform_device *pdev)
 {
+       struct at91_usbh_data   *pdata = pdev->dev.platform_data;
+       int                     i;
+
+       if (pdata) {
+               /* REVISIT make the driver support per-port power switching,
+                * and also overcurrent detection.  Here we assume the ports
+                * are always powered while this driver is active, and use
+                * active-low power switches.
+                */
+               for (i = 0; i < pdata->ports; i++) {
+                       if (pdata->vbus_pin[i] <= 0)
+                               continue;
+                       gpio_request(pdata->vbus_pin[i], "ohci_vbus");
+                       gpio_direction_output(pdata->vbus_pin[i], 0);
+               }
+       }
+
        device_init_wakeup(&pdev->dev, 1);
        return usb_hcd_at91_probe(&ohci_at91_hc_driver, pdev);
 }
 
 static int ohci_hcd_at91_drv_remove(struct platform_device *pdev)
 {
+       struct at91_usbh_data   *pdata = pdev->dev.platform_data;
+       int                     i;
+
+       if (pdata) {
+               for (i = 0; i < pdata->ports; i++) {
+                       if (pdata->vbus_pin[i] <= 0)
+                               continue;
+                       gpio_direction_output(pdata->vbus_pin[i], 1);
+                       gpio_free(pdata->vbus_pin[i]);
+               }
+       }
+
        device_init_wakeup(&pdev->dev, 0);
        return usb_hcd_at91_remove(platform_get_drvdata(pdev), pdev);
 }