usbnet: Stop RX Q on MTU change
authorSoohoon Lee <Soohoon.Lee@f5.com>
Wed, 29 Jun 2016 19:07:21 +0000 (15:07 -0400)
committerDavid S. Miller <davem@davemloft.net>
Thu, 30 Jun 2016 13:05:05 +0000 (09:05 -0400)
When MTU is changed unlink_urbs() flushes RX Q but mean while usbnet_bh()
can fill up the Q at the same time.
Depends on which HCD is down there unlink takes long time then the flush
never ends.

Signed-off-by: Soohoon Lee <soohoon.lee@f5.com>
Reviewed-by: Kimball Murray <kmurray@f5.com>
Signed-off-by: David S. Miller <davem@davemloft.net>
drivers/net/usb/usbnet.c

index 61ba464049374593316e1c0b869774861ee79b5e..6086a0163249c5e05d8cdf92b1b834c3da4a71a7 100644 (file)
@@ -395,8 +395,11 @@ int usbnet_change_mtu (struct net_device *net, int new_mtu)
        dev->hard_mtu = net->mtu + net->hard_header_len;
        if (dev->rx_urb_size == old_hard_mtu) {
                dev->rx_urb_size = dev->hard_mtu;
-               if (dev->rx_urb_size > old_rx_urb_size)
+               if (dev->rx_urb_size > old_rx_urb_size) {
+                       usbnet_pause_rx(dev);
                        usbnet_unlink_rx_urbs(dev);
+                       usbnet_resume_rx(dev);
+               }
        }
 
        /* max qlen depend on hard_mtu and rx_urb_size */
@@ -1508,8 +1511,9 @@ static void usbnet_bh (unsigned long param)
        } else if (netif_running (dev->net) &&
                   netif_device_present (dev->net) &&
                   netif_carrier_ok(dev->net) &&
-                  !timer_pending (&dev->delay) &&
-                  !test_bit (EVENT_RX_HALT, &dev->flags)) {
+                  !timer_pending(&dev->delay) &&
+                  !test_bit(EVENT_RX_PAUSED, &dev->flags) &&
+                  !test_bit(EVENT_RX_HALT, &dev->flags)) {
                int     temp = dev->rxq.qlen;
 
                if (temp < RX_QLEN(dev)) {