dt: bindings: add new dt entry for ath10k calibration variant

The bus + bmi-chip-id + bmi-board-id is not enough to identify the correct
board data file on QCA4019 based devices. Multiple different boards share
the same values. Only the original reference designs can currently be
identified and loaded from the board-2.bin. But these will not result in
the correct calibration data when combined with the pre-calibration data
from the device.

An additional "variant" information has to be provided (via SMBIOS or DT)
to select the correct board data for a design which was modified by an ODM.

Signed-off-by: Sven Eckelmann <sven.eckelmann@openmesh.com>
Signed-off-by: Kalle Valo <kvalo@qca.qualcomm.com>

diff --git a/Documentation/devicetree/bindings/net/wireless/qcom,ath10k.txt b/Documentation/devicetree/bindings/net/wireless/qcom,ath10k.txt
index 74d7f0af209c8178f078b99a9dd460d44d430f8c..3d2a031217da0851acad1ce8cc1716b376801adc 100644 (file)
--- a/Documentation/devicetree/bindings/net/wireless/qcom,ath10k.txt
+++ b/Documentation/devicetree/bindings/net/wireless/qcom,ath10k.txt
@@ -41,6 +41,9 @@ Optional properties:
 - qcom,msi_addr: MSI interrupt address.
 - qcom,msi_base: Base value to add before writing MSI data into
                MSI address register.
+- qcom,ath10k-calibration-variant: string to search for in the board-2.bin
+                                  variant list with the same bus and device
+                                  specific ids
 - qcom,ath10k-calibration-data : calibration data + board specific data
                                 as an array, the length can vary between
                                 hw versions.