net: mvpp2: initialize the GMAC when using a port
authorAntoine Ténart <antoine.tenart@free-electrons.com>
Tue, 22 Aug 2017 17:08:24 +0000 (19:08 +0200)
committerDavid S. Miller <davem@davemloft.net>
Tue, 22 Aug 2017 21:32:19 +0000 (14:32 -0700)
This adds a routine to initialize the GMAC at the port level when using
a port. This wasn't done until this commit, and the mvpp2 driver was
relying on the bootloader/firmware initialization. This doesn't mean
everything is configured in the mvpp2 driver now, but it helps reducing
the gap.

Signed-off-by: Antoine Tenart <antoine.tenart@free-electrons.com>
Tested-by: Marcin Wojtas <mw@semihalf.com>
Signed-off-by: David S. Miller <davem@davemloft.net>
drivers/net/ethernet/marvell/mvpp2.c

index 087eb793ab4d02191697d6d001e3b67dc553fb7e..2ab7366ac90f1cb01ae6417af02b54b4a96f9fb0 100644 (file)
 /* Per-port registers */
 #define MVPP2_GMAC_CTRL_0_REG                  0x0
 #define     MVPP2_GMAC_PORT_EN_MASK            BIT(0)
+#define     MVPP2_GMAC_PORT_TYPE_MASK          BIT(1)
 #define     MVPP2_GMAC_MAX_RX_SIZE_OFFS                2
 #define     MVPP2_GMAC_MAX_RX_SIZE_MASK                0x7ffc
 #define     MVPP2_GMAC_MIB_CNTR_EN_MASK                BIT(15)
 #define     MVPP2_GMAC_SA_LOW_OFFS             7
 #define MVPP2_GMAC_CTRL_2_REG                  0x8
 #define     MVPP2_GMAC_INBAND_AN_MASK          BIT(0)
+#define     MVPP2_GMAC_FLOW_CTRL_MASK          GENMASK(2, 1)
 #define     MVPP2_GMAC_PCS_ENABLE_MASK         BIT(3)
 #define     MVPP2_GMAC_PORT_RGMII_MASK         BIT(4)
+#define     MVPP2_GMAC_DISABLE_PADDING         BIT(5)
 #define     MVPP2_GMAC_PORT_RESET_MASK         BIT(6)
 #define MVPP2_GMAC_AUTONEG_CONFIG              0xc
 #define     MVPP2_GMAC_FORCE_LINK_DOWN         BIT(0)
 #define     MVPP2_GMAC_FORCE_LINK_PASS         BIT(1)
+#define     MVPP2_GMAC_IN_BAND_AUTONEG         BIT(2)
+#define     MVPP2_GMAC_IN_BAND_AUTONEG_BYPASS  BIT(3)
 #define     MVPP2_GMAC_CONFIG_MII_SPEED        BIT(5)
 #define     MVPP2_GMAC_CONFIG_GMII_SPEED       BIT(6)
 #define     MVPP2_GMAC_AN_SPEED_EN             BIT(7)
 #define     MVPP2_GMAC_FC_ADV_EN               BIT(9)
+#define     MVPP2_GMAC_FLOW_CTRL_AUTONEG       BIT(11)
 #define     MVPP2_GMAC_CONFIG_FULL_DUPLEX      BIT(12)
 #define     MVPP2_GMAC_AN_DUPLEX_EN            BIT(13)
 #define MVPP2_GMAC_PORT_FIFO_CFG_1_REG         0x1c
@@ -4245,6 +4251,92 @@ mvpp2_shared_interrupt_mask_unmask(struct mvpp2_port *port, bool mask)
 
 /* Port configuration routines */
 
+static void mvpp2_port_mii_gmac_configure_mode(struct mvpp2_port *port)
+{
+       u32 val;
+
+       if (port->phy_interface == PHY_INTERFACE_MODE_SGMII) {
+               val = readl(port->base + MVPP22_GMAC_CTRL_4_REG);
+               val |= MVPP22_CTRL4_SYNC_BYPASS_DIS | MVPP22_CTRL4_DP_CLK_SEL |
+                      MVPP22_CTRL4_QSGMII_BYPASS_ACTIVE;
+               val &= ~MVPP22_CTRL4_EXT_PIN_GMII_SEL;
+               writel(val, port->base + MVPP22_GMAC_CTRL_4_REG);
+
+               val = readl(port->base + MVPP2_GMAC_CTRL_2_REG);
+               val |= MVPP2_GMAC_DISABLE_PADDING;
+               val &= ~MVPP2_GMAC_FLOW_CTRL_MASK;
+               writel(val, port->base + MVPP2_GMAC_CTRL_2_REG);
+       } else if (port->phy_interface == PHY_INTERFACE_MODE_RGMII ||
+                  port->phy_interface == PHY_INTERFACE_MODE_RGMII_ID ||
+                  port->phy_interface == PHY_INTERFACE_MODE_RGMII_RXID ||
+                  port->phy_interface == PHY_INTERFACE_MODE_RGMII_TXID) {
+               val = readl(port->base + MVPP22_GMAC_CTRL_4_REG);
+               val |= MVPP22_CTRL4_EXT_PIN_GMII_SEL |
+                      MVPP22_CTRL4_SYNC_BYPASS_DIS |
+                      MVPP22_CTRL4_QSGMII_BYPASS_ACTIVE;
+               val &= ~MVPP22_CTRL4_DP_CLK_SEL;
+               writel(val, port->base + MVPP22_GMAC_CTRL_4_REG);
+
+               val = readl(port->base + MVPP2_GMAC_CTRL_2_REG);
+               val &= ~MVPP2_GMAC_DISABLE_PADDING;
+               writel(val, port->base + MVPP2_GMAC_CTRL_2_REG);
+       }
+
+       /* The port is connected to a copper PHY */
+       val = readl(port->base + MVPP2_GMAC_CTRL_0_REG);
+       val &= ~MVPP2_GMAC_PORT_TYPE_MASK;
+       writel(val, port->base + MVPP2_GMAC_CTRL_0_REG);
+
+       val = readl(port->base + MVPP2_GMAC_AUTONEG_CONFIG);
+       val |= MVPP2_GMAC_IN_BAND_AUTONEG_BYPASS |
+              MVPP2_GMAC_AN_SPEED_EN | MVPP2_GMAC_FLOW_CTRL_AUTONEG |
+              MVPP2_GMAC_AN_DUPLEX_EN;
+       if (port->phy_interface == PHY_INTERFACE_MODE_SGMII)
+               val |= MVPP2_GMAC_IN_BAND_AUTONEG;
+       writel(val, port->base + MVPP2_GMAC_AUTONEG_CONFIG);
+}
+
+static void mvpp2_port_mii_gmac_configure(struct mvpp2_port *port)
+{
+       u32 val;
+
+       /* Force link down */
+       val = readl(port->base + MVPP2_GMAC_AUTONEG_CONFIG);
+       val &= ~MVPP2_GMAC_FORCE_LINK_PASS;
+       val |= MVPP2_GMAC_FORCE_LINK_DOWN;
+       writel(val, port->base + MVPP2_GMAC_AUTONEG_CONFIG);
+
+       /* Set the GMAC in a reset state */
+       val = readl(port->base + MVPP2_GMAC_CTRL_2_REG);
+       val |= MVPP2_GMAC_PORT_RESET_MASK;
+       writel(val, port->base + MVPP2_GMAC_CTRL_2_REG);
+
+       /* Configure the PCS and in-band AN */
+       val = readl(port->base + MVPP2_GMAC_CTRL_2_REG);
+       if (port->phy_interface == PHY_INTERFACE_MODE_SGMII) {
+               val |= MVPP2_GMAC_INBAND_AN_MASK | MVPP2_GMAC_PCS_ENABLE_MASK;
+       } else if (port->phy_interface == PHY_INTERFACE_MODE_RGMII ||
+                  port->phy_interface == PHY_INTERFACE_MODE_RGMII_ID ||
+                  port->phy_interface == PHY_INTERFACE_MODE_RGMII_RXID ||
+                  port->phy_interface == PHY_INTERFACE_MODE_RGMII_TXID) {
+               val &= ~MVPP2_GMAC_PCS_ENABLE_MASK;
+               val |= MVPP2_GMAC_PORT_RGMII_MASK;
+       }
+       writel(val, port->base + MVPP2_GMAC_CTRL_2_REG);
+
+       mvpp2_port_mii_gmac_configure_mode(port);
+
+       /* Unset the GMAC reset state */
+       val = readl(port->base + MVPP2_GMAC_CTRL_2_REG);
+       val &= ~MVPP2_GMAC_PORT_RESET_MASK;
+       writel(val, port->base + MVPP2_GMAC_CTRL_2_REG);
+
+       /* Stop forcing link down */
+       val = readl(port->base + MVPP2_GMAC_AUTONEG_CONFIG);
+       val &= ~MVPP2_GMAC_FORCE_LINK_DOWN;
+       writel(val, port->base + MVPP2_GMAC_AUTONEG_CONFIG);
+}
+
 static void mvpp22_port_mii_set(struct mvpp2_port *port)
 {
        u32 val;
@@ -4262,38 +4354,19 @@ static void mvpp22_port_mii_set(struct mvpp2_port *port)
 
                writel(val, port->base + MVPP22_XLG_CTRL3_REG);
        }
-
-       val = readl(port->base + MVPP22_GMAC_CTRL_4_REG);
-       if (port->phy_interface == PHY_INTERFACE_MODE_RGMII)
-               val |= MVPP22_CTRL4_EXT_PIN_GMII_SEL;
-       else
-               val &= ~MVPP22_CTRL4_EXT_PIN_GMII_SEL;
-       val &= ~MVPP22_CTRL4_DP_CLK_SEL;
-       val |= MVPP22_CTRL4_SYNC_BYPASS_DIS;
-       val |= MVPP22_CTRL4_QSGMII_BYPASS_ACTIVE;
-       writel(val, port->base + MVPP22_GMAC_CTRL_4_REG);
 }
 
 static void mvpp2_port_mii_set(struct mvpp2_port *port)
 {
-       u32 val;
-
        if (port->priv->hw_version == MVPP22)
                mvpp22_port_mii_set(port);
 
-       val = readl(port->base + MVPP2_GMAC_CTRL_2_REG);
-
-       switch (port->phy_interface) {
-       case PHY_INTERFACE_MODE_SGMII:
-               val |= MVPP2_GMAC_INBAND_AN_MASK;
-               break;
-       case PHY_INTERFACE_MODE_RGMII:
-               val |= MVPP2_GMAC_PORT_RGMII_MASK;
-       default:
-               val &= ~MVPP2_GMAC_PCS_ENABLE_MASK;
-       }
-
-       writel(val, port->base + MVPP2_GMAC_CTRL_2_REG);
+       if (port->phy_interface == PHY_INTERFACE_MODE_RGMII ||
+           port->phy_interface == PHY_INTERFACE_MODE_RGMII_ID ||
+           port->phy_interface == PHY_INTERFACE_MODE_RGMII_RXID ||
+           port->phy_interface == PHY_INTERFACE_MODE_RGMII_TXID ||
+           port->phy_interface == PHY_INTERFACE_MODE_SGMII)
+               mvpp2_port_mii_gmac_configure(port);
 }
 
 static void mvpp2_port_fc_adv_enable(struct mvpp2_port *port)