mtd: nand: gpmi-nand: Remove wrong Kconfig help text

The GPMI nand Kconfig help texts mentions that the GPMI nand driver
might conflict with SD cards. The only conflict there might really
be is that both controllers use the same pins, but this is resolved
by the pincontroller setup in the device tree. In any way the GPMI
driver can safely be enabled, the text is just wrong. Remove it.

Signed-off-by: Sascha Hauer <s.hauer@pengutronix.de>
Reviewed-by: Fabio Estevam <fabio.estevam@nxp.com>
Acked-by: Han Xu <han.xu@nxp.com>
Signed-off-by: Boris Brezillon <boris.brezillon@free-electrons.com>

diff --git a/drivers/mtd/nand/Kconfig b/drivers/mtd/nand/Kconfig
index bb48aafed9a2d2fcead8fd44ae5c571d7c3bb02f..859eb7790c4668468bc8354a0febeb47b6c5eb14 100644 (file)
--- a/drivers/mtd/nand/Kconfig
+++ b/drivers/mtd/nand/Kconfig
@@ -376,9 +376,7 @@ config MTD_NAND_GPMI_NAND
         Enables NAND Flash support for IMX23, IMX28 or IMX6.
         The GPMI controller is very powerful, with the help of BCH
         module, it can do the hardware ECC. The GPMI supports several
-        NAND flashs at the same time. The GPMI may conflicts with other
-        block, such as SD card. So pay attention to it when you enable
-        the GPMI.
+        NAND flashs at the same time.
 
 config MTD_NAND_BRCMNAND
        tristate "Broadcom STB NAND controller"