return ret;
}
+static int mei_gfx_memory_ready(struct mei_cl_device *cldev)
+{
+ struct mkhi_gfx_mem_ready req = {0};
+ unsigned int mode = MEI_CL_IO_TX_INTERNAL;
+
+ req.hdr.group_id = MKHI_GROUP_ID_GFX;
+ req.hdr.command = MKHI_GFX_MEMORY_READY_CMD_REQ;
+ req.flags = MKHI_GFX_MEM_READY_PXP_ALLOWED;
+
+ dev_dbg(&cldev->dev, "Sending memory ready command\n");
+ return __mei_cl_send(cldev->cl, (u8 *)&req, sizeof(req), 0, mode);
+}
+
static void mei_mkhi_fix(struct mei_cl_device *cldev)
{
int ret;
dev_err(&cldev->dev, "FW version command failed %d\n", ret);
mei_cldev_disable(cldev);
}
+
+static void mei_gsc_mkhi_fix_ver(struct mei_cl_device *cldev)
+{
+ int ret;
+
+ /* No need to enable the client if nothing is needed from it */
+ if (!cldev->bus->fw_f_fw_ver_supported &&
+ cldev->bus->pxp_mode != MEI_DEV_PXP_INIT)
+ return;
+
+ ret = mei_cldev_enable(cldev);
+ if (ret)
+ return;
+
+ if (cldev->bus->pxp_mode == MEI_DEV_PXP_INIT) {
+ ret = mei_gfx_memory_ready(cldev);
+ if (ret < 0)
+ dev_err(&cldev->dev, "memory ready command failed %d\n", ret);
+ else
+ dev_dbg(&cldev->dev, "memory ready command sent\n");
+ /* we go to reset after that */
+ cldev->bus->pxp_mode = MEI_DEV_PXP_SETUP;
+ goto out;
+ }
+
+ ret = mei_fwver(cldev);
+ if (ret < 0)
+ dev_err(&cldev->dev, "FW version command failed %d\n",
+ ret);
+out:
+ mei_cldev_disable(cldev);
+}
+
/**
* mei_wd - wd client on the bus, change protocol version
* as the API has changed.
cldev->do_match = 1;
}
+/**
+ * pxp_is_ready - enable bus client if pxp is ready
+ *
+ * @cldev: me clients device
+ */
+static void pxp_is_ready(struct mei_cl_device *cldev)
+{
+ struct mei_device *bus = cldev->bus;
+
+ switch (bus->pxp_mode) {
+ case MEI_DEV_PXP_READY:
+ case MEI_DEV_PXP_DEFAULT:
+ cldev->do_match = 1;
+ break;
+ default:
+ cldev->do_match = 0;
+ break;
+ }
+}
+
#define MEI_FIXUP(_uuid, _hook) { _uuid, _hook }
static struct mei_fixup {
MEI_FIXUP(MEI_UUID_WD, mei_wd),
MEI_FIXUP(MEI_UUID_MKHIF_FIX, mei_mkhi_fix),
MEI_FIXUP(MEI_UUID_IGSC_MKHI, mei_gsc_mkhi_ver),
- MEI_FIXUP(MEI_UUID_IGSC_MKHI_FIX, mei_gsc_mkhi_ver),
+ MEI_FIXUP(MEI_UUID_IGSC_MKHI_FIX, mei_gsc_mkhi_fix_ver),
MEI_FIXUP(MEI_UUID_HDCP, whitelist),
MEI_FIXUP(MEI_UUID_ANY, vt_support),
- MEI_FIXUP(MEI_UUID_PAVP, whitelist),
+ MEI_FIXUP(MEI_UUID_PAVP, pxp_is_ready),
};
/**
return 0;
}
+static void mei_gsc_set_ext_op_mem(const struct mei_me_hw *hw, struct resource *mem)
+{
+ u32 low = lower_32_bits(mem->start);
+ u32 hi = upper_32_bits(mem->start);
+ u32 limit = (resource_size(mem) / SZ_4K) | GSC_EXT_OP_MEM_VALID;
+
+ iowrite32(low, hw->mem_addr + H_GSC_EXT_OP_MEM_BASE_ADDR_LO_REG);
+ iowrite32(hi, hw->mem_addr + H_GSC_EXT_OP_MEM_BASE_ADDR_HI_REG);
+ iowrite32(limit, hw->mem_addr + H_GSC_EXT_OP_MEM_LIMIT_REG);
+}
+
static int mei_gsc_probe(struct auxiliary_device *aux_dev,
const struct auxiliary_device_id *aux_dev_id)
{
dev_set_drvdata(device, dev);
+ if (adev->ext_op_mem.start) {
+ mei_gsc_set_ext_op_mem(hw, &adev->ext_op_mem);
+ dev->pxp_mode = MEI_DEV_PXP_INIT;
+ }
+
/* use polling */
if (mei_me_hw_use_polling(hw)) {
mei_disable_interrupts(dev);
/* SPDX-License-Identifier: GPL-2.0 OR BSD-3-Clause */
/*
- * Copyright (c) 2003-2019, Intel Corporation. All rights reserved.
+ * Copyright (c) 2003-2022, Intel Corporation. All rights reserved.
* Intel Management Engine Interface (Intel MEI) Linux driver
*/
#ifndef _MEI_HW_MEI_REGS_H_
# define PCI_CFG_HFS_3_FW_SKU_SPS 0x00000060
#define PCI_CFG_HFS_4 0x64
#define PCI_CFG_HFS_5 0x68
+# define GSC_CFG_HFS_5_BOOT_TYPE_MSK 0x00000003
+# define GSC_CFG_HFS_5_BOOT_TYPE_PXP 3
#define PCI_CFG_HFS_6 0x6C
/* MEI registers */
/* H_D0I3C - D0I3 Control */
#define H_D0I3C 0x800
+#define H_GSC_EXT_OP_MEM_BASE_ADDR_LO_REG 0x100
+#define H_GSC_EXT_OP_MEM_BASE_ADDR_HI_REG 0x104
+#define H_GSC_EXT_OP_MEM_LIMIT_REG 0x108
+#define GSC_EXT_OP_MEM_VALID BIT(31)
+
/* register bits of H_CSR (Host Control Status register) */
/* Host Circular Buffer Depth - maximum number of 32-bit entries in CB */
#define H_CBD 0xFF000000
return (mecsr & ME_RST_HRA) == ME_RST_HRA;
}
+/**
+ * mei_gsc_pxp_check - check for gsc firmware entering pxp mode
+ *
+ * @dev: the device structure
+ */
+static void mei_gsc_pxp_check(struct mei_device *dev)
+{
+ struct mei_me_hw *hw = to_me_hw(dev);
+ u32 fwsts5 = 0;
+
+ if (dev->pxp_mode == MEI_DEV_PXP_DEFAULT)
+ return;
+
+ hw->read_fws(dev, PCI_CFG_HFS_5, &fwsts5);
+ trace_mei_pci_cfg_read(dev->dev, "PCI_CFG_HFS_5", PCI_CFG_HFS_5, fwsts5);
+ if ((fwsts5 & GSC_CFG_HFS_5_BOOT_TYPE_MSK) == GSC_CFG_HFS_5_BOOT_TYPE_PXP) {
+ dev_dbg(dev->dev, "pxp mode is ready 0x%08x\n", fwsts5);
+ dev->pxp_mode = MEI_DEV_PXP_READY;
+ } else {
+ dev_dbg(dev->dev, "pxp mode is not ready 0x%08x\n", fwsts5);
+ }
+}
+
/**
* mei_me_hw_ready_wait - wait until the me(hw) has turned ready
* or timeout is reached
return -ETIME;
}
+ mei_gsc_pxp_check(dev);
+
mei_me_hw_reset_release(dev);
dev->recvd_hw_ready = false;
return 0;
/* check if ME wants a reset */
if (!mei_hw_is_ready(dev) && dev->dev_state != MEI_DEV_RESETTING) {
- dev_warn(dev->dev, "FW not ready: resetting.\n");
+ dev_warn(dev->dev, "FW not ready: resetting: dev_state = %d pxp = %d\n",
+ dev->dev_state, dev->pxp_mode);
if (dev->dev_state == MEI_DEV_POWERING_DOWN ||
dev->dev_state == MEI_DEV_POWER_DOWN)
mei_cl_all_disconnect(dev);
bitmap_zero(dev->host_clients_map, MEI_CLIENTS_MAX);
dev->open_handle_count = 0;
+ dev->pxp_mode = MEI_DEV_PXP_DEFAULT;
+
/*
* Reserving the first client ID
* 0: Reserved for MEI Bus Message communications
MEI_DEV_POWER_UP
};
+/**
+ * enum mei_dev_pxp_mode - MEI PXP mode state
+ *
+ * @MEI_DEV_PXP_DEFAULT: PCH based device, no initailization required
+ * @MEI_DEV_PXP_INIT: device requires initialization, send setup message to firmware
+ * @MEI_DEV_PXP_SETUP: device is in setup stage, waiting for firmware repsonse
+ * @MEI_DEV_PXP_READY: device initialized
+ */
+enum mei_dev_pxp_mode {
+ MEI_DEV_PXP_DEFAULT = 0,
+ MEI_DEV_PXP_INIT = 1,
+ MEI_DEV_PXP_SETUP = 2,
+ MEI_DEV_PXP_READY = 3,
+};
+
const char *mei_dev_state_str(int state);
enum mei_file_transaction_states {
* @reset_count : number of consecutive resets
* @dev_state : device state
* @hbm_state : state of host bus message protocol
+ * @pxp_mode : PXP device mode
* @init_clients_timer : HBM init handshake timeout
*
* @pg_event : power gating event
unsigned long reset_count;
enum mei_dev_state dev_state;
enum mei_hbm_state hbm_state;
+ enum mei_dev_pxp_mode pxp_mode;
u16 init_clients_timer;
/*
* @aux_dev: - auxiliary device object
* @irq: interrupt driving the mei auxiliary device
* @bar: mmio resource bar reserved to mei auxiliary device
+ * @ext_op_mem: resource for extend operational memory
+ * used in graphics PXP mode.
* @slow_firmware: The device has slow underlying firmware.
* Such firmware will require to use larger operation timeouts.
*/
struct auxiliary_device aux_dev;
int irq;
struct resource bar;
+ struct resource ext_op_mem;
bool slow_firmware;
};
projects / linux-2.6-block.git / commitdiff