net: phy: qcom: at803x: Avoid hibernating if MAC requires RX clock

Stmmac controllers connected to an at803x PHY cannot resume properly after
suspend when WoL is enabled. This happens because the MAC requires an RX
clock generated by the PHY to initialize its hardware properly. But the RX
clock is cut when the PHY suspends and isn't brought up until the MAC
driver resumes the phylink.

Prevent the at803x PHY driver from going into suspend if the attached MAC
driver always requires an RX clock signal.

Reported-by: Clark Wang <xiaoning.wang@nxp.com>
Link: https://lore.kernel.org/all/20230202081559.3553637-1-xiaoning.wang@nxp.com/
Signed-off-by: Russell King (Oracle) <rmk+kernel@armlinux.org.uk>
[rgantois: commit log]
Signed-off-by: Romain Gantois <romain.gantois@bootlin.com>
Reviewed-by: Andrew Lunn <andrew@lunn.ch>
Link: https://lore.kernel.org/r/20240326-rxc_bugfix-v6-6-24a74e5c761f@bootlin.com
Signed-off-by: Jakub Kicinski <kuba@kernel.org>

diff --git a/drivers/net/phy/qcom/at803x.c b/drivers/net/phy/qcom/at803x.c
index e79657f76bea238ceb79c0b3c45c989b08f7592e..c8f83e5f78ab9c74d69aa4030185653d04bba430 100644 (file)
--- a/drivers/net/phy/qcom/at803x.c
+++ b/drivers/net/phy/qcom/at803x.c
@@ -426,7 +426,8 @@ static int at803x_hibernation_mode_config(struct phy_device *phydev)
        /* The default after hardware reset is hibernation mode enabled. After
         * software reset, the value is retained.
         */
-       if (!(priv->flags & AT803X_DISABLE_HIBERNATION_MODE))
+       if (!(priv->flags & AT803X_DISABLE_HIBERNATION_MODE) &&
+           !(phydev->dev_flags & PHY_F_RXC_ALWAYS_ON))
                return 0;
 
        return at803x_debug_reg_mask(phydev, AT803X_DEBUG_REG_HIB_CTRL,