#define IS_VF_FLAG (1 << 22)
#define BC_SUPPORTS_RMMOD_CMD (1 << 23)
#define HAS_PHYS_PORT_ID (1 << 24)
-#define AER_ENABLED (1 << 25)
#define PTP_SUPPORTED (1 << 26)
#define TX_TIMESTAMPING_EN (1 << 27)
#include <linux/slab.h>
#include <linux/interrupt.h>
#include <linux/pci.h>
-#include <linux/aer.h>
#include <linux/init.h>
#include <linux/netdevice.h>
#include <linux/etherdevice.h>
.ndo_features_check = bnx2x_features_check,
};
-static void bnx2x_disable_pcie_error_reporting(struct bnx2x *bp)
-{
- if (bp->flags & AER_ENABLED) {
- pci_disable_pcie_error_reporting(bp->pdev);
- bp->flags &= ~AER_ENABLED;
- }
-}
-
static int bnx2x_init_dev(struct bnx2x *bp, struct pci_dev *pdev,
struct net_device *dev, unsigned long board_type)
{
/* Set PCIe reset type to fundamental for EEH recovery */
pdev->needs_freset = 1;
- /* AER (Advanced Error reporting) configuration */
- rc = pci_enable_pcie_error_reporting(pdev);
- if (!rc)
- bp->flags |= AER_ENABLED;
- else
- BNX2X_DEV_INFO("Failed To configure PCIe AER [%d]\n", rc);
-
/*
* Clean the following indirect addresses for all functions since it
* is not used by the driver.
bnx2x_free_mem_bp(bp);
init_one_exit:
- bnx2x_disable_pcie_error_reporting(bp);
-
if (bp->regview)
iounmap(bp->regview);
pci_set_power_state(pdev, PCI_D3hot);
}
- bnx2x_disable_pcie_error_reporting(bp);
if (remove_netdev) {
if (bp->regview)
iounmap(bp->regview);