int ret;
bcm3510_register_value v;
- /* read Acquisation Processor status register and check it is not in RUN mode */
+ /* read Acquisition Processor status register and check it is not in RUN mode */
if ((ret = bcm3510_readB(st,0xa2,&v)) < 0)
return ret;
if (v.APSTAT1_a2.RUN) {
#define SOC_8090_P1G_11R1 0x86
#define SOC_8090_P1G_21R1 0x8e
-/* else use thos ones to check */
+/* else use those ones to check */
#define P1A_B 0x0
#define P1C 0x1
#define P1D_E_F 0x3
if (((state->identity.version & 0x1f) >= P1D_E_F) || (state->identity.in_soc))
dib0090_set_EFUSE(state);
- /* Congigure in function of the crystal */
+ /* Configure in function of the crystal */
if (state->config->force_crystal_mode != 0)
dib0090_write_reg(state, 0x14,
state->config->force_crystal_mode & 3);
return 0;
}
-/* see dib3000-watch dvb-apps for exact calcuations of signal_strength and snr */
+/* see dib3000-watch dvb-apps for exact calculations of signal_strength and snr */
static int dib3000mb_read_signal_strength(struct dvb_frontend* fe, u16 *strength)
{
struct dib3000_state* state = fe->demodulator_priv;
};
/*
- * This table is 6 dB too low comapred to the others (probably created with
+ * This table is 6 dB too low compared to the others (probably created with
* a different BB_MAG setting)
*/
static const struct slookup gain_channel_agc_nf_lookup[] = {
Capprox = 255;
- /* TODO Temperature compensation. There is defenitely a scale factor */
+ /* TODO Temperature compensation. There is definitely a scale factor */
/* missing in the datasheet, so leave it out for now. */
state->m_Regs[EB14] = Capprox;
int ret;
if (zl10036_debug & 0x02) {
- /* every 8bit-value satisifes this!
+ /* every 8bit-value satisfies this!
* so only check for debug log */
if ((buf[0] & 0x80) == 0x00)
reg = 2;