xfs: force all buffers to be written during btree bulk load

xfs: force all buffers to be written during btree bulk load

While stress-testing online repair of btrees, I noticed periodic
assertion failures from the buffer cache about buffers with incorrect
DELWRI_Q state.  Looking further, I observed this race between the AIL
trying to write out a btree block and repair zapping a btree block after
the fact:

AIL:    Repair0:

pin buffer X
delwri_queue:
set DELWRI_Q
add to delwri list

        stale buf X:
        clear DELWRI_Q
        does not clear b_list
        free space X
        commit

delwri_submit   # oops

Worse yet, I discovered that running the same repair over and over in a
tight loop can result in a second race that cause data integrity
problems with the repair:

AIL:    Repair0:        Repair1:

pin buffer X
delwri_queue:
set DELWRI_Q
add to delwri list

        stale buf X:
        clear DELWRI_Q
        does not clear b_list
        free space X
        commit

                        find free space X
                        get buffer
                        rewrite buffer
                        delwri_queue:
                        set DELWRI_Q
                        already on a list, do not add
                        commit

                        BAD: committed tree root before all blocks written

delwri_submit   # too late now

I traced this to my own misunderstanding of how the delwri lists work,
particularly with regards to the AIL's buffer list.  If a buffer is
logged and committed, the buffer can end up on that AIL buffer list.  If
btree repairs are run twice in rapid succession, it's possible that the
first repair will invalidate the buffer and free it before the next time
the AIL wakes up.  Marking the buffer stale clears DELWRI_Q from the
buffer state without removing the buffer from its delwri list.  The
buffer doesn't know which list it's on, so it cannot know which lock to
take to protect the list for a removal.

If the second repair allocates the same block, it will then recycle the
buffer to start writing the new btree block.  Meanwhile, if the AIL
wakes up and walks the buffer list, it will ignore the buffer because it
can't lock it, and go back to sleep.

When the second repair calls delwri_queue to put the buffer on the
list of buffers to write before committing the new btree, it will set
DELWRI_Q again, but since the buffer hasn't been removed from the AIL's
buffer list, it won't add it to the bulkload buffer's list.

This is incorrect, because the bulkload caller relies on delwri_submit
to ensure that all the buffers have been sent to disk /before/
committing the new btree root pointer.  This ordering requirement is
required for data consistency.

Worse, the AIL won't clear DELWRI_Q from the buffer when it does finally
drop it, so the next thread to walk through the btree will trip over a
debug assertion on that flag.

To fix this, create a new function that waits for the buffer to be
removed from any other delwri lists before adding the buffer to the
caller's delwri list.  By waiting for the buffer to clear both the
delwri list and any potential delwri wait list, we can be sure that
repair will initiate writes of all buffers and report all write errors
back to userspace instead of committing the new structure.

Signed-off-by: Darrick J. Wong <djwong@kernel.org>
Reviewed-by: Christoph Hellwig <hch@lst.de>