Bluetooth: hci_core: Enable buffer flow control for SCO/eSCO

Bluetooth: hci_core: Enable buffer flow control for SCO/eSCO

This enables buffer flow control for SCO/eSCO
(see: Bluetooth Core 6.0 spec: 6.22. Synchronous Flow Control Enable),
recently this has caused the following problem and is actually a nice
addition for the likes of Socket TX complete:

< HCI Command: Read Buffer Size (0x04|0x0005) plen 0
> HCI Event: Command Complete (0x0e) plen 11
      Read Buffer Size (0x04|0x0005) ncmd 1
        Status: Success (0x00)
        ACL MTU: 1021 ACL max packet: 5
        SCO MTU: 240  SCO max packet: 8
...
< SCO Data TX: Handle 257 flags 0x00 dlen 120
< SCO Data TX: Handle 257 flags 0x00 dlen 120
< SCO Data TX: Handle 257 flags 0x00 dlen 120
< SCO Data TX: Handle 257 flags 0x00 dlen 120
< SCO Data TX: Handle 257 flags 0x00 dlen 120
< SCO Data TX: Handle 257 flags 0x00 dlen 120
< SCO Data TX: Handle 257 flags 0x00 dlen 120
< SCO Data TX: Handle 257 flags 0x00 dlen 120
< SCO Data TX: Handle 257 flags 0x00 dlen 120
> HCI Event: Hardware Error (0x10) plen 1
        Code: 0x0a

To fix the code will now attempt to enable buffer flow control when
HCI_QUIRK_SYNC_FLOWCTL_SUPPORTED is set by the driver:

< HCI Command: Write Sync Fl.. (0x03|0x002f) plen 1
        Flow control: Enabled (0x01)
> HCI Event: Command Complete (0x0e) plen 4
      Write Sync Flow Control Enable (0x03|0x002f) ncmd 1
        Status: Success (0x00)

On success then HCI_SCO_FLOWCTL would be set which indicates sco_cnt
shall be used for flow contro.

Fixes: 7fedd3bb6b77 ("Bluetooth: Prioritize SCO traffic")
Signed-off-by: Luiz Augusto von Dentz <luiz.von.dentz@intel.com>
Tested-by: Pauli Virtanen <pav@iki.fi>