{
u8 *v_addr;
dma_addr_t p_addr;
- u32 offset, chunk_sz = section->len;
+ u32 offset, chunk_sz = min_t(u32, FH_MEM_TB_MAX_LENGTH, section->len);
int ret = 0;
IWL_DEBUG_FW(trans, "[%d] uCode section being loaded...\n",
/* Stop the device, and put it in low power state */
iwl_pcie_apm_stop(trans, false);
- /* Upon stop, the APM issues an interrupt if HW RF kill is set.
- * Clean again the interrupt here
+ /* stop and reset the on-board processor */
+ iwl_write32(trans, CSR_RESET, CSR_RESET_REG_FLAG_SW_RESET);
+ udelay(20);
+
+ /*
+ * Upon stop, the APM issues an interrupt if HW RF kill is set.
+ * This is a bug in certain verions of the hardware.
+ * Certain devices also keep sending HW RF kill interrupt all
+ * the time, unless the interrupt is ACKed even if the interrupt
+ * should be masked. Re-ACK all the interrupts here.
*/
spin_lock(&trans_pcie->irq_lock);
iwl_disable_interrupts(trans);
spin_unlock(&trans_pcie->irq_lock);
- /* stop and reset the on-board processor */
- iwl_write32(trans, CSR_RESET, CSR_RESET_REG_FLAG_SW_RESET);
- udelay(20);
/* clear all status bits */
clear_bit(STATUS_SYNC_HCMD_ACTIVE, &trans->status);