* IV. Notes
* The current error (XDU, RFO) recovery code is untested.
* So far, RDO takes his RX channel down and the right sequence to enable it
- * again is still a mistery. If RDO happens, plan a reboot. More details
+ * again is still a mystery. If RDO happens, plan a reboot. More details
* in the code (NB: as this happens, TX still works).
* Don't mess the cables during operation, especially on DTE ports. I don't
* suggest it for DCE either but at least one can get some messages instead
/*
* Due to various bugs, there is no way to reliably reset a
- * specific port (manufacturer's dependant special PCI #RST wiring
+ * specific port (manufacturer's dependent special PCI #RST wiring
* apart: it affects all ports). Thus the device goes in the best
* silent mode possible at dscc4_close() time and simply claims to
* be up if it's opened again. It still isn't possible to change
* scaling. Of course some rounding may take place.
* - no high speed mode (40Mb/s). May be trivial to do but I don't have an
* appropriate external clocking device for testing.
- * - no time-slot/clock mode 5: shameless lazyness.
+ * - no time-slot/clock mode 5: shameless laziness.
*
- * The clock signals wiring can be (is ?) manufacturer dependant. Good luck.
+ * The clock signals wiring can be (is ?) manufacturer dependent. Good luck.
*
* BIG FAT WARNING: if the device isn't provided enough clocking signal, it
* won't pass the init sequence. For example, straight back-to-back DTE without