#define E1000_CTRL_EXT_LINK_MODE_PCIE_SERDES 0x00C00000
#define E1000_CTRL_EXT_LINK_MODE_1000BASE_KX 0x00400000
#define E1000_CTRL_EXT_LINK_MODE_SGMII 0x00800000
+#define E1000_CTRL_EXT_LINK_MODE_GMII 0x00000000
#define E1000_CTRL_EXT_EIAME 0x01000000
#define E1000_CTRL_EXT_IRCA 0x00000001
/* Interrupt delay cancellation */
/* Management Control */
#define E1000_MANC_SMBUS_EN 0x00000001 /* SMBus Enabled - RO */
#define E1000_MANC_ASF_EN 0x00000002 /* ASF Enabled - RO */
+#define E1000_MANC_EN_BMC2OS 0x10000000 /* OSBMC is Enabled or not */
/* Enable Neighbor Discovery Filtering */
#define E1000_MANC_RCV_TCO_EN 0x00020000 /* Receive TCO Packets Enabled */
#define E1000_MANC_BLK_PHY_RST_ON_IDE 0x00040000 /* Block phy resets */
#define E1000_TCTL_COLD 0x003ff000 /* collision distance */
#define E1000_TCTL_RTLC 0x01000000 /* Re-transmit on late collision */
-/* Transmit Arbitration Count */
+/* DMA Coalescing register fields */
+#define E1000_DMACR_DMACWT_MASK 0x00003FFF /* DMA Coalescing
+ * Watchdog Timer */
+#define E1000_DMACR_DMACTHR_MASK 0x00FF0000 /* DMA Coalescing Receive
+ * Threshold */
+#define E1000_DMACR_DMACTHR_SHIFT 16
+#define E1000_DMACR_DMAC_LX_MASK 0x30000000 /* Lx when no PCIe
+ * transactions */
+#define E1000_DMACR_DMAC_LX_SHIFT 28
+#define E1000_DMACR_DMAC_EN 0x80000000 /* Enable DMA Coalescing */
+
+#define E1000_DMCTXTH_DMCTTHR_MASK 0x00000FFF /* DMA Coalescing Transmit
+ * Threshold */
+
+#define E1000_DMCTLX_TTLX_MASK 0x00000FFF /* Time to LX request */
+
+#define E1000_DMCRTRH_UTRESH_MASK 0x0007FFFF /* Receive Traffic Rate
+ * Threshold */
+#define E1000_DMCRTRH_LRPRCW 0x80000000 /* Rcv packet rate in
+ * current window */
+
+#define E1000_DMCCNT_CCOUNT_MASK 0x01FFFFFF /* DMA Coal Rcv Traffic
+ * Current Cnt */
+
+#define E1000_FCRTC_RTH_COAL_MASK 0x0003FFF0 /* Flow ctrl Rcv Threshold
+ * High val */
+#define E1000_FCRTC_RTH_COAL_SHIFT 4
+#define E1000_PCIEMISC_LX_DECISION 0x00000080 /* Lx power decision */
/* SerDes Control */
#define E1000_SCTL_DISABLE_SERDES_LOOPBACK 0x0400
#define NVM_INIT_CONTROL3_PORT_A 0x0024
#define NVM_ALT_MAC_ADDR_PTR 0x0037
#define NVM_CHECKSUM_REG 0x003F
+#define NVM_COMPATIBILITY_REG_3 0x0003
+#define NVM_COMPATIBILITY_BIT_MASK 0x8000
#define E1000_NVM_CFG_DONE_PORT_0 0x040000 /* MNG config cycle done */
#define E1000_NVM_CFG_DONE_PORT_1 0x080000 /* ...for second port */
/* NVM Commands - SPI */
#define NVM_MAX_RETRY_SPI 5000 /* Max wait of 5ms, for RDY signal */
#define NVM_WRITE_OPCODE_SPI 0x02 /* NVM write opcode */
+#define NVM_READ_OPCODE_SPI 0x03 /* NVM read opcode */
#define NVM_A8_OPCODE_SPI 0x08 /* opcode bit-3 = address bit-8 */
#define NVM_WREN_OPCODE_SPI 0x06 /* NVM set Write Enable latch */
#define NVM_RDSR_OPCODE_SPI 0x05 /* NVM read Status register */
#define E1000_MDIC_ERROR 0x40000000
#define E1000_MDIC_DEST 0x80000000
+/* Thermal Sensor */
+#define E1000_THSTAT_PWR_DOWN 0x00000001 /* Power Down Event */
+#define E1000_THSTAT_LINK_THROTTLE 0x00000002 /* Link Speed Throttle Event */
+
+/* Energy Efficient Ethernet */
+#define E1000_IPCNFG_EEE_1G_AN 0x00000008 /* EEE Enable 1G AN */
+#define E1000_IPCNFG_EEE_100M_AN 0x00000004 /* EEE Enable 100M AN */
+#define E1000_EEER_TX_LPI_EN 0x00010000 /* EEE Tx LPI Enable */
+#define E1000_EEER_RX_LPI_EN 0x00020000 /* EEE Rx LPI Enable */
+#define E1000_EEER_LPI_FC 0x00040000 /* EEE Enable on FC */
+
/* SerDes Control */
#define E1000_GEN_CTL_READY 0x80000000
#define E1000_GEN_CTL_ADDRESS_SHIFT 8
#define E1000_PCIEMISC_LX_DECISION 0x00000080 /* Lx power decision based
on DMA coal */
+/* Tx Rate-Scheduler Config fields */
+#define E1000_RTTBCNRC_RS_ENA 0x80000000
+#define E1000_RTTBCNRC_RF_DEC_MASK 0x00003FFF
+#define E1000_RTTBCNRC_RF_INT_SHIFT 14
+#define E1000_RTTBCNRC_RF_INT_MASK \
+ (E1000_RTTBCNRC_RF_DEC_MASK << E1000_RTTBCNRC_RF_INT_SHIFT)
+
#endif
projects / linux-block.git / blobdiff