This option enables support for on-chip LED drivers found on Marvell
Semiconductor 88PM8606 PMIC.
+config LEDS_AAT1290
+ tristate "LED support for the AAT1290"
+ depends on LEDS_CLASS_FLASH
+ depends on V4L2_FLASH_LED_CLASS || !V4L2_FLASH_LED_CLASS
+ depends on GPIOLIB
+ depends on OF
+ depends on PINCTRL
+ help
+ This option enables support for the LEDs on the AAT1290.
+
+config LEDS_BCM6328
+ tristate "LED Support for Broadcom BCM6328"
+ depends on LEDS_CLASS
+ depends on OF
+ help
+ This option enables support for LEDs connected to the BCM6328
+ LED HW controller accessed via MMIO registers.
+
+config LEDS_BCM6358
+ tristate "LED Support for Broadcom BCM6358"
+ depends on LEDS_CLASS
+ depends on OF
+ help
+ This option enables support for LEDs connected to the BCM6358
+ LED HW controller accessed via MMIO registers.
+
config LEDS_LM3530
tristate "LCD Backlight driver for LM3530"
depends on LEDS_CLASS
config LEDS_GPIO
tristate "LED Support for GPIO connected LEDs"
depends on LEDS_CLASS
- depends on GPIOLIB
+ depends on GPIOLIB || COMPILE_TEST
help
This option enables support for the LEDs connected to GPIO
outputs. To be useful the particular board must have LEDs
tristate "Common Driver for TI/National LP5521/5523/55231/5562/8501"
depends on LEDS_LP5521 || LEDS_LP5523 || LEDS_LP5562 || LEDS_LP8501
select FW_LOADER
+ select FW_LOADER_USER_HELPER_FALLBACK
help
This option supports common operations for LP5521/5523/55231/5562/8501
devices.
LED driver chips accessed via the I2C bus.
Driver support brightness control and hardware-assisted blinking.
+config LEDS_TLC591XX
+ tristate "LED driver for TLC59108 and TLC59116 controllers"
+ depends on LEDS_CLASS && I2C
+ select REGMAP_I2C
+ help
+ This option enables support for Texas Instruments TLC59108
+ and TLC59116 LED controllers.
+
+config LEDS_MAX77693
+ tristate "LED support for MAX77693 Flash"
+ depends on LEDS_CLASS_FLASH
+ depends on V4L2_FLASH_LED_CLASS || !V4L2_FLASH_LED_CLASS
+ depends on MFD_MAX77693
+ depends on OF
+ help
+ This option enables support for the flash part of the MAX77693
+ multifunction device. It has build in control for two leds in flash
+ and torch mode.
+
config LEDS_MAX8997
tristate "LED support for MAX8997 PMIC"
depends on LEDS_CLASS && MFD_MAX8997
This driver can also be built as a module. If so the module
will be called leds-menf21bmc.
+config LEDS_KTD2692
+ tristate "LED support for KTD2692 flash LED controller"
+ depends on LEDS_CLASS_FLASH && GPIOLIB && OF
+ help
+ This option enables support for KTD2692 LED flash connected
+ through ExpressWire interface.
+
+ Say Y to enable this driver.
+
comment "LED driver for blink(1) USB RGB LED is under Special HID drivers (HID_THINGM)"
config LEDS_BLINKM