myri10ge: support new firmware counters

[linux-2.6-block.git] / drivers / ata / pata_opti.c

diff --git a/drivers/ata/pata_opti.c b/drivers/ata/pata_opti.c
index da1aa148b37d9f69b5d91c88b57608f1e7d65461..13b63e21838d9ff94c0be60051c5a6e1190e78ee 100644 (file)
--- a/drivers/ata/pata_opti.c
+++ b/drivers/ata/pata_opti.c
@@ -34,7 +34,7 @@
 #include <linux/libata.h>
 
 #define DRV_NAME "pata_opti"
-#define DRV_VERSION "0.2.7"
+#define DRV_VERSION "0.2.9"
 
 enum {
        READ_REG        = 0,    /* index of Read cycle timing register */
@@ -61,8 +61,6 @@ static int opti_pre_reset(struct ata_port *ap)
 
        if (!pci_test_config_bits(pdev, &opti_enable_bits[ap->port_no]))
                return -ENOENT;
-
-       ap->cbl = ATA_CBL_PATA40;
        return ata_std_prereset(ap);
 }
 
@@ -179,8 +177,10 @@ static struct scsi_host_template opti_sht = {
        .slave_configure        = ata_scsi_slave_config,
        .slave_destroy          = ata_scsi_slave_destroy,
        .bios_param             = ata_std_bios_param,
+#ifdef CONFIG_PM
        .resume                 = ata_scsi_device_resume,
        .suspend                = ata_scsi_device_suspend,
+#endif
 };
 
 static struct ata_port_operations opti_port_ops = {
@@ -196,6 +196,7 @@ static struct ata_port_operations opti_port_ops = {
        .thaw           = ata_bmdma_thaw,
        .error_handler  = opti_error_handler,
        .post_internal_cmd = ata_bmdma_post_internal_cmd,
+       .cable_detect   = ata_cable_40wire,
 
        .bmdma_setup    = ata_bmdma_setup,
        .bmdma_start    = ata_bmdma_start,
@@ -244,8 +245,10 @@ static struct pci_driver opti_pci_driver = {
        .id_table       = opti,
        .probe          = opti_init_one,
        .remove         = ata_pci_remove_one,
+#ifdef CONFIG_PM
        .suspend        = ata_pci_device_suspend,
        .resume         = ata_pci_device_resume,
+#endif
 };
 
 static int __init opti_init(void)