#include <asm/percpu.h>
#include <asm/topology.h>
#include <asm/apicdef.h>
+#include <asm/k8.h>
#ifdef CONFIG_X86_64
#include <asm/numa_64.h>
#endif
#ifdef CONFIG_KEXEC
-/**
- * Reserve @size bytes of crashkernel memory at any suitable offset.
- *
- * @size: Size of the crashkernel memory to reserve.
- * Returns the base address on success, and -1ULL on failure.
- */
-static
-unsigned long long __init find_and_reserve_crashkernel(unsigned long long size)
-{
- const unsigned long long alignment = 16<<20; /* 16M */
- unsigned long long start = 0LL;
-
- while (1) {
- int ret;
-
- start = find_e820_area(start, ULONG_MAX, size, alignment);
- if (start == -1ULL)
- return start;
-
- /* try to reserve it */
- ret = reserve_bootmem_generic(start, size, BOOTMEM_EXCLUSIVE);
- if (ret >= 0)
- return start;
-
- start += alignment;
- }
-}
-
static inline unsigned long long get_total_mem(void)
{
unsigned long long total;
- total = max_low_pfn - min_low_pfn;
-#ifdef CONFIG_HIGHMEM
- total += highend_pfn - highstart_pfn;
-#endif
+ total = max_pfn - min_low_pfn;
return total << PAGE_SHIFT;
}
/* 0 means: find the address automatically */
if (crash_base <= 0) {
- crash_base = find_and_reserve_crashkernel(crash_size);
+ const unsigned long long alignment = 16<<20; /* 16M */
+
+ crash_base = find_e820_area(alignment, ULONG_MAX, crash_size,
+ alignment);
if (crash_base == -1ULL) {
- pr_info("crashkernel reservation failed. "
- "No suitable area found.\n");
+ pr_info("crashkernel reservation failed - No suitable area found.\n");
return;
}
} else {
- ret = reserve_bootmem_generic(crash_base, crash_size,
- BOOTMEM_EXCLUSIVE);
- if (ret < 0) {
- pr_info("crashkernel reservation failed - "
- "memory is in use\n");
+ unsigned long long start;
+
+ start = find_e820_area(crash_base, ULONG_MAX, crash_size,
+ 1<<20);
+ if (start != crash_base) {
+ pr_info("crashkernel reservation failed - memory is in use.\n");
return;
}
}
+ reserve_early(crash_base, crash_base + crash_size, "CRASH KERNEL");
printk(KERN_INFO "Reserving %ldMB of memory at %ldMB "
"for crashkernel (System RAM: %ldMB)\n",
{}
};
+static void __init trim_bios_range(void)
+{
+ /*
+ * A special case is the first 4Kb of memory;
+ * This is a BIOS owned area, not kernel ram, but generally
+ * not listed as such in the E820 table.
+ */
+ e820_update_range(0, PAGE_SIZE, E820_RAM, E820_RESERVED);
+ /*
+ * special case: Some BIOSen report the PC BIOS
+ * area (640->1Mb) as ram even though it is not.
+ * take them out.
+ */
+ e820_remove_range(BIOS_BEGIN, BIOS_END - BIOS_BEGIN, E820_RAM, 1);
+ sanitize_e820_map(e820.map, ARRAY_SIZE(e820.map), &e820.nr_map);
+}
+
/*
* Determine if we were loaded by an EFI loader. If so, then we have also been
* passed the efi memmap, systab, etc., so we should use these data structures
void __init setup_arch(char **cmdline_p)
{
+ int acpi = 0;
+ int k8 = 0;
+
#ifdef CONFIG_X86_32
memcpy(&boot_cpu_data, &new_cpu_data, sizeof(new_cpu_data));
visws_early_detect();
strlcpy(command_line, boot_command_line, COMMAND_LINE_SIZE);
*cmdline_p = command_line;
-#ifdef CONFIG_X86_64
/*
- * Must call this twice: Once just to detect whether hardware doesn't
- * support NX (so that the early EHCI debug console setup can safely
- * call set_fixmap(), and then again after parsing early parameters to
- * honor the respective command line option.
+ * x86_configure_nx() is called before parse_early_param() to detect
+ * whether hardware doesn't support NX (so that the early EHCI debug
+ * console setup can safely call set_fixmap()). It may then be called
+ * again from within noexec_setup() during parsing early parameters
+ * to honor the respective command line option.
*/
- check_efer();
-#endif
+ x86_configure_nx();
parse_early_param();
-#ifdef CONFIG_X86_64
- check_efer();
-#endif
+ x86_report_nx();
/* Must be before kernel pagetables are setup */
vmi_activate();
insert_resource(&iomem_resource, &data_resource);
insert_resource(&iomem_resource, &bss_resource);
-
+ trim_bios_range();
#ifdef CONFIG_X86_32
if (ppro_with_ram_bug()) {
e820_update_range(0x70000000ULL, 0x40000ULL, E820_RAM,
reserve_brk();
+#ifdef CONFIG_ACPI_SLEEP
+ /*
+ * Reserve low memory region for sleep support.
+ * even before init_memory_mapping
+ */
+ acpi_reserve_wakeup_memory();
+#endif
init_gbpages();
/* max_pfn_mapped is updated here */
reserve_initrd();
+ reserve_crashkernel();
+
vsmp_init();
io_delay_init();
early_acpi_boot_init();
+ /*
+ * Find and reserve possible boot-time SMP configuration:
+ */
+ find_smp_config();
+
#ifdef CONFIG_ACPI_NUMA
/*
* Parse SRAT to discover nodes.
*/
- acpi_numa_init();
+ acpi = acpi_numa_init();
#endif
- initmem_init(0, max_pfn);
-
-#ifdef CONFIG_ACPI_SLEEP
- /*
- * Reserve low memory region for sleep support.
- */
- acpi_reserve_bootmem();
+#ifdef CONFIG_K8_NUMA
+ if (!acpi)
+ k8 = !k8_numa_init(0, max_pfn);
#endif
- /*
- * Find and reserve possible boot-time SMP configuration:
- */
- find_smp_config();
- reserve_crashkernel();
+ initmem_init(0, max_pfn, acpi, k8);
#ifdef CONFIG_X86_64
/*
projects / linux-block.git / blobdiff