* f1000000 on-chip peripheral registers
* f2000000 PCIe I/O space
* f3000000 NAND controller address window
+ * f4000000 Security Accelerator SRAM
*
* virt phys size
* fee00000 f1000000 1M on-chip peripheral registers
* fef00000 f2000000 1M PCIe I/O space
*/
+#define KIRKWOOD_SRAM_PHYS_BASE 0xf4000000
+#define KIRKWOOD_SRAM_SIZE SZ_2K
+
#define KIRKWOOD_NAND_MEM_PHYS_BASE 0xf3000000
-#define KIRKWOOD_NAND_MEM_SIZE SZ_64K /* 1K is sufficient, but 64K
- * is the minimal window size
- */
+#define KIRKWOOD_NAND_MEM_SIZE SZ_1K
#define KIRKWOOD_PCIE_IO_PHYS_BASE 0xf2000000
#define KIRKWOOD_PCIE_IO_VIRT_BASE 0xfef00000
#define KIRKWOOD_PCIE_MEM_PHYS_BASE 0xe0000000
#define KIRKWOOD_PCIE_MEM_SIZE SZ_128M
-/*
- * MBUS bridge registers.
- */
-#define BRIDGE_VIRT_BASE (KIRKWOOD_REGS_VIRT_BASE | 0x20000)
-#define CPU_CONTROL (BRIDGE_VIRT_BASE | 0x0104)
-#define CPU_RESET 0x00000002
-#define RSTOUTn_MASK (BRIDGE_VIRT_BASE | 0x0108)
-#define SOFT_RESET_OUT_EN 0x00000004
-#define SYSTEM_SOFT_RESET (BRIDGE_VIRT_BASE | 0x010c)
-#define SOFT_RESET 0x00000001
-#define BRIDGE_CAUSE (BRIDGE_VIRT_BASE | 0x0110)
-#define BRIDGE_MASK (BRIDGE_VIRT_BASE | 0x0114)
-#define BRIDGE_INT_TIMER0 0x0002
-#define BRIDGE_INT_TIMER1 0x0004
-#define BRIDGE_INT_TIMER1_CLR (~0x0004)
-#define IRQ_VIRT_BASE (BRIDGE_VIRT_BASE | 0x0200)
-#define IRQ_CAUSE_LOW_OFF 0x0000
-#define IRQ_MASK_LOW_OFF 0x0004
-#define IRQ_CAUSE_HIGH_OFF 0x0010
-#define IRQ_MASK_HIGH_OFF 0x0014
-#define TIMER_VIRT_BASE (BRIDGE_VIRT_BASE | 0x0300)
-#define L2_CONFIG_REG (BRIDGE_VIRT_BASE | 0x0128)
-#define L2_WRITETHROUGH 0x00000010
-
-/*
- * Supported devices and revisions.
- */
-#define MV88F6281_DEV_ID 0x6281
-#define MV88F6281_REV_Z0 0
-#define MV88F6281_REV_A0 2
-
-#define MV88F6192_DEV_ID 0x6192
-#define MV88F6192_REV_Z0 0
-#define MV88F6192_REV_A0 2
-
-#define MV88F6180_DEV_ID 0x6180
-#define MV88F6180_REV_A0 2
-
/*
* Register Map
*/
#define DDR_VIRT_BASE (KIRKWOOD_REGS_VIRT_BASE | 0x00000)
#define DDR_WINDOW_CPU_BASE (DDR_VIRT_BASE | 0x1500)
+#define DDR_OPERATION_BASE (DDR_VIRT_BASE | 0x1418)
#define DEV_BUS_PHYS_BASE (KIRKWOOD_REGS_PHYS_BASE | 0x10000)
#define DEV_BUS_VIRT_BASE (KIRKWOOD_REGS_VIRT_BASE | 0x10000)
#define UART1_PHYS_BASE (DEV_BUS_PHYS_BASE | 0x2100)
#define UART1_VIRT_BASE (DEV_BUS_VIRT_BASE | 0x2100)
+#define BRIDGE_VIRT_BASE (KIRKWOOD_REGS_VIRT_BASE | 0x20000)
+
+#define CRYPTO_PHYS_BASE (KIRKWOOD_REGS_PHYS_BASE | 0x30000)
+
#define PCIE_VIRT_BASE (KIRKWOOD_REGS_VIRT_BASE | 0x40000)
+#define PCIE_LINK_CTRL (PCIE_VIRT_BASE | 0x70)
+#define PCIE_STATUS (PCIE_VIRT_BASE | 0x1a04)
#define USB_PHYS_BASE (KIRKWOOD_REGS_PHYS_BASE | 0x50000)
#define GE01_PHYS_BASE (KIRKWOOD_REGS_PHYS_BASE | 0x74000)
#define SATA_PHYS_BASE (KIRKWOOD_REGS_PHYS_BASE | 0x80000)
+#define SATA_VIRT_BASE (KIRKWOOD_REGS_VIRT_BASE | 0x80000)
+#define SATA0_IF_CTRL (SATA_VIRT_BASE | 0x2050)
+#define SATA0_PHY_MODE_2 (SATA_VIRT_BASE | 0x2330)
+#define SATA1_IF_CTRL (SATA_VIRT_BASE | 0x4050)
+#define SATA1_PHY_MODE_2 (SATA_VIRT_BASE | 0x4330)
#define SDIO_PHYS_BASE (KIRKWOOD_REGS_PHYS_BASE | 0x90000)
+/*
+ * Supported devices and revisions.
+ */
+#define MV88F6281_DEV_ID 0x6281
+#define MV88F6281_REV_Z0 0
+#define MV88F6281_REV_A0 2
+
+#define MV88F6192_DEV_ID 0x6192
+#define MV88F6192_REV_Z0 0
+#define MV88F6192_REV_A0 2
+
+#define MV88F6180_DEV_ID 0x6180
+#define MV88F6180_REV_A0 2
#endif