select ARCH_HAS_SYNC_DMA_FOR_CPU
select ARCH_HAS_SYNC_DMA_FOR_DEVICE
select ARCH_SUPPORTS_ATOMIC_RMW if ARC_HAS_LLSC
+ select ARCH_32BIT_OFF_T
select BUILDTIME_EXTABLE_SORT
select CLONE_BACKWARDS
select COMMON_CLK
config ARC_SMP_HALT_ON_RESET
bool "Enable Halt-on-reset boot mode"
- default y if ARC_UBOOT_SUPPORT
help
In SMP configuration cores can be configured as Halt-on-reset
or they could all start at same time. For Halt-on-reset, non
(also referred to as r58:r59). These can also be used by gcc as GPR so
kernel needs to save/restore per process
+config ARC_IRQ_NO_AUTOSAVE
+ bool "Disable hardware autosave regfile on interrupts"
+ default n
+ help
+ On HS cores, taken interrupt auto saves the regfile on stack.
+ This is programmable and can be optionally disabled in which case
+ software INTERRUPT_PROLOGUE/EPILGUE do the needed work
+
endif # ISA_ARCV2
endmenu # "ARC CPU Configuration"
endif
-config ARC_UBOOT_SUPPORT
- bool "Support uboot arg Handling"
- help
- ARC Linux by default checks for uboot provided args as pointers to
- external cmdline or DTB. This however breaks in absence of uboot,
- when booting from Metaware debugger directly, as the registers are
- not zeroed out on reset by mdb and/or ARCv2 based cores. The bogus
- registers look like uboot args to kernel which then chokes.
- So only enable the uboot arg checking/processing if users are sure
- of uboot being in play.
-
config ARC_BUILTIN_DTB_NAME
string "Built in DTB"
help