docs: move mips under arch

[linux-block.git] / Documentation / mips / booting.rst

diff --git a/Documentation/mips/booting.rst b/Documentation/mips/booting.rst
deleted file mode 100644 (file)
index 7c18a4e..0000000
--- a/Documentation/mips/booting.rst
+++ /dev/null
@@ -1,28 +0,0 @@
-.. SPDX-License-Identifier: GPL-2.0
-
-BMIPS DeviceTree Booting
-------------------------
-
-  Some bootloaders only support a single entry point, at the start of the
-  kernel image.  Other bootloaders will jump to the ELF start address.
-  Both schemes are supported; CONFIG_BOOT_RAW=y and CONFIG_NO_EXCEPT_FILL=y,
-  so the first instruction immediately jumps to kernel_entry().
-
-  Similar to the arch/arm case (b), a DT-aware bootloader is expected to
-  set up the following registers:
-
-         a0 : 0
-
-         a1 : 0xffffffff
-
-         a2 : Physical pointer to the device tree block (defined in chapter
-         II) in RAM.  The device tree can be located anywhere in the first
-         512MB of the physical address space (0x00000000 - 0x1fffffff),
-         aligned on a 64 bit boundary.
-
-  Legacy bootloaders do not use this convention, and they do not pass in a
-  DT block.  In this case, Linux will look for a builtin DTB, selected via
-  CONFIG_DT_*.
-
-  This convention is defined for 32-bit systems only, as there are not
-  currently any 64-bit BMIPS implementations.