usbcore.blinkenlights=1
+Hyphens (dashes) and underscores are equivalent in parameter names, so
+ log_buf_len=1M print-fatal-signals=1
+can also be entered as
+ log-buf-len=1M print_fatal_signals=1
+
+
This document may not be entirely up to date and comprehensive. The command
"modinfo -p ${modulename}" shows a current list of all parameters of a loadable
module. Loadable modules, after being loaded into the running kernel, also
ISAPNP ISA PnP code is enabled.
ISDN Appropriate ISDN support is enabled.
JOY Appropriate joystick support is enabled.
- KMEMTRACE kmemtrace is enabled.
LIBATA Libata driver is enabled
LP Printer support is enabled.
LOOP Loopback device support is enabled.
not play well with APC CPU idle - disable it if you have
APC and your system crashes randomly.
- apic= [APIC,i386] Advanced Programmable Interrupt Controller
+ apic= [APIC,X86-32] Advanced Programmable Interrupt Controller
Change the output verbosity whilst booting
Format: { quiet (default) | verbose | debug }
Change the amount of debugging information output
to discrete, to make X server driver able to add WB
entry later. This parameter enables that.
- enable_timer_pin_1 [i386,x86-64]
+ enable_timer_pin_1 [X86]
Enable PIN 1 of APIC timer
Can be useful to work around chipset bugs
(in particular on some ATI chipsets).
ia64_pal_cache_flush instead of SAL_CACHE_FLUSH.
ftrace=[tracer]
- [ftrace] will set and start the specified tracer
+ [FTRACE] will set and start the specified tracer
as early as possible in order to facilitate early
boot debugging.
ftrace_dump_on_oops
- [ftrace] will dump the trace buffers on oops.
+ [FTRACE] will dump the trace buffers on oops.
+
+ ftrace_filter=[function-list]
+ [FTRACE] Limit the functions traced by the function
+ tracer at boot up. function-list is a comma separated
+ list of functions. This list can be changed at run
+ time by the set_ftrace_filter file in the debugfs
+ tracing directory.
+
+ ftrace_notrace=[function-list]
+ [FTRACE] Do not trace the functions specified in
+ function-list. This list can be changed at run time
+ by the set_ftrace_notrace file in the debugfs
+ tracing directory.
gamecon.map[2|3]=
[HW,JOY] Multisystem joystick and NES/SNES/PSX pad
hashdist= [KNL,NUMA] Large hashes allocated during boot
are distributed across NUMA nodes. Defaults on
- for IA-64, off otherwise.
+ for 64bit NUMA, off otherwise.
Format: 0 | 1 (for off | on)
hcl= [IA-64] SGI's Hardware Graph compatibility layer
use the HighMem zone if it exists, and the Normal
zone if it does not.
- kmemtrace.enable= [KNL,KMEMTRACE] Format: { yes | no }
- Controls whether kmemtrace is enabled
- at boot-time.
-
- kmemtrace.subbufs=n [KNL,KMEMTRACE] Overrides the number of
- subbufs kmemtrace's relay channel has. Set this
- higher than default (KMEMTRACE_N_SUBBUFS in code) if
- you experience buffer overruns.
-
kgdboc= [HW] kgdb over consoles.
Requires a tty driver that supports console polling.
(only serial suported for now)