+/**
+ * usb_new_device - perform initial device setup (usbcore-internal)
+ * @udev: newly addressed device (in ADDRESS state)
+ *
+ * This is called with devices which have been enumerated, but not yet
+ * configured. The device descriptor is available, but not descriptors
+ * for any device configuration. The caller must have locked either
+ * the parent hub (if udev is a normal device) or else the
+ * usb_bus_list_lock (if udev is a root hub). The parent's pointer to
+ * udev has already been installed, but udev is not yet visible through
+ * sysfs or other filesystem code.
+ *
+ * The return value for this function depends on if the
+ * multithread_probe variable is set or not. If it's set, it will
+ * return a if the probe thread was successfully created or not. If the
+ * variable is not set, it will return if the device is configured
+ * properly or not. interfaces, in sysfs); else a negative errno value.
+ *
+ * This call is synchronous, and may not be used in an interrupt context.
+ *
+ * Only the hub driver or root-hub registrar should ever call this.
+ */
+int usb_new_device(struct usb_device *udev)
+{
+ struct task_struct *probe_task;
+ int ret = 0;
+
+ if (multithread_probe) {
+ probe_task = kthread_run(__usb_new_device, udev,
+ "usb-probe-%s", udev->devnum);
+ if (IS_ERR(probe_task))
+ ret = PTR_ERR(probe_task);
+ } else
+ ret = __usb_new_device(udev);
+
+ return ret;
+}