| | 1 | # SPDX-License-Identifier: GPL-2.0 |
| | 2 | # |
| | 3 | # Makefile for the Linux kernel device drivers. |
| | 4 | # |
| | 5 | # 15 Sep 2000, Christoph Hellwig <hch@infradead.org> |
| | 6 | # Rewritten to use lists instead of if-statements. |
| | 7 | # |
| | 8 | |
| | 9 | obj-y += cache/ |
| | 10 | obj-y += irqchip/ |
| | 11 | obj-y += bus/ |
| | 12 | |
| | 13 | obj-$(CONFIG_GENERIC_PHY) += phy/ |
| | 14 | |
| | 15 | # GPIO must come after pinctrl as gpios may need to mux pins etc |
| | 16 | obj-$(CONFIG_PINCTRL) += pinctrl/ |
| | 17 | obj-$(CONFIG_GPIOLIB) += gpio/ |
| | 18 | obj-y += pwm/ |
| | 19 | |
| | 20 | obj-y += pci/ |
| | 21 | |
| | 22 | obj-$(CONFIG_PARISC) += parisc/ |
| | 23 | obj-$(CONFIG_RAPIDIO) += rapidio/ |
| | 24 | obj-y += video/ |
| | 25 | obj-y += idle/ |
| | 26 | |
| | 27 | # IPMI must come before ACPI in order to provide IPMI opregion support |
| | 28 | obj-y += char/ipmi/ |
| | 29 | |
| | 30 | obj-$(CONFIG_ACPI) += acpi/ |
| | 31 | |
| | 32 | # PnP must come after ACPI since it will eventually need to check if acpi |
| | 33 | # was used and do nothing if so |
| | 34 | obj-$(CONFIG_PNP) += pnp/ |
| | 35 | obj-y += amba/ |
| | 36 | |
| | 37 | obj-y += clk/ |
| | 38 | # Many drivers will want to use DMA so this has to be made available |
| | 39 | # really early. |
| | 40 | obj-$(CONFIG_DMADEVICES) += dma/ |
| | 41 | |
| | 42 | # SOC specific infrastructure drivers. |
| | 43 | obj-y += soc/ |
| | 44 | obj-$(CONFIG_PM_GENERIC_DOMAINS) += pmdomain/ |
| | 45 | |
| | 46 | obj-y += virtio/ |
| | 47 | obj-$(CONFIG_VDPA) += vdpa/ |
| | 48 | obj-$(CONFIG_XEN) += xen/ |
| | 49 | |
| | 50 | # regulators early, since some subsystems rely on them to initialize |
| | 51 | obj-$(CONFIG_REGULATOR) += regulator/ |
| | 52 | |
| | 53 | # reset controllers early, since gpu drivers might rely on them to initialize |
| | 54 | obj-$(CONFIG_RESET_CONTROLLER) += reset/ |
| | 55 | |
| | 56 | # tty/ comes before char/ so that the VT console is the boot-time |
| | 57 | # default. |
| | 58 | obj-y += tty/ |
| | 59 | obj-y += char/ |
| | 60 | |
| | 61 | # iommu/ comes before gpu as gpu are using iommu controllers |
| | 62 | obj-y += iommu/ |
| | 63 | |
| | 64 | # gpu/ comes after char for AGP vs DRM startup and after iommu |
| | 65 | obj-y += gpu/ |
| | 66 | |
| | 67 | obj-$(CONFIG_CONNECTOR) += connector/ |
| | 68 | |
| | 69 | # i810fb depends on char/agp/ |
| | 70 | obj-$(CONFIG_FB_I810) += video/fbdev/i810/ |
| | 71 | |
| | 72 | obj-$(CONFIG_PARPORT) += parport/ |
| | 73 | obj-y += base/ block/ misc/ mfd/ nfc/ |
| | 74 | obj-$(CONFIG_LIBNVDIMM) += nvdimm/ |
| | 75 | obj-y += dax/ |
| | 76 | obj-$(CONFIG_DMA_SHARED_BUFFER) += dma-buf/ |
| | 77 | obj-$(CONFIG_NUBUS) += nubus/ |
| | 78 | obj-y += cxl/ |
| | 79 | obj-y += macintosh/ |
| | 80 | obj-y += scsi/ |
| | 81 | obj-y += nvme/ |
| | 82 | obj-$(CONFIG_ATA) += ata/ |
| | 83 | obj-$(CONFIG_TARGET_CORE) += target/ |
| | 84 | obj-$(CONFIG_MTD) += mtd/ |
| | 85 | obj-$(CONFIG_SPI) += spi/ |
| | 86 | obj-$(CONFIG_SPMI) += spmi/ |
| | 87 | obj-$(CONFIG_HSI) += hsi/ |
| | 88 | obj-$(CONFIG_SLIMBUS) += slimbus/ |
| | 89 | obj-y += net/ |
| | 90 | obj-$(CONFIG_ATM) += atm/ |
| | 91 | obj-$(CONFIG_FUSION) += message/ |
| | 92 | obj-y += firewire/ |
| | 93 | obj-$(CONFIG_UIO) += uio/ |
| | 94 | obj-$(CONFIG_VFIO) += vfio/ |
| | 95 | obj-y += cdrom/ |
| | 96 | obj-y += auxdisplay/ |
| | 97 | obj-$(CONFIG_PCCARD) += pcmcia/ |
| | 98 | obj-$(CONFIG_DIO) += dio/ |
| | 99 | obj-$(CONFIG_SBUS) += sbus/ |
| | 100 | obj-$(CONFIG_ZORRO) += zorro/ |
| | 101 | obj-$(CONFIG_ATA_OVER_ETH) += block/aoe/ |
| | 102 | obj-$(CONFIG_TC) += tc/ |
| | 103 | obj-$(CONFIG_USB_PHY) += usb/ |
| | 104 | obj-$(CONFIG_USB) += usb/ |
| | 105 | obj-$(CONFIG_USB_SUPPORT) += usb/ |
| | 106 | obj-$(CONFIG_PCI) += usb/ |
| | 107 | obj-$(CONFIG_USB_GADGET) += usb/ |
| | 108 | obj-$(CONFIG_OF) += usb/ |
| | 109 | obj-$(CONFIG_SERIO) += input/serio/ |
| | 110 | obj-$(CONFIG_GAMEPORT) += input/gameport/ |
| | 111 | obj-$(CONFIG_INPUT) += input/ |
| | 112 | obj-$(CONFIG_RTC_LIB) += rtc/ |
| | 113 | obj-y += i2c/ i3c/ media/ |
| | 114 | obj-$(CONFIG_PPS) += pps/ |
| | 115 | obj-y += ptp/ |
| | 116 | obj-$(CONFIG_W1) += w1/ |
| | 117 | obj-y += power/ |
| | 118 | obj-$(CONFIG_HWMON) += hwmon/ |
| | 119 | obj-$(CONFIG_THERMAL) += thermal/ |
| | 120 | obj-$(CONFIG_WATCHDOG) += watchdog/ |
| | 121 | obj-$(CONFIG_MD) += md/ |
| | 122 | obj-$(CONFIG_BT) += bluetooth/ |
| | 123 | obj-$(CONFIG_ACCESSIBILITY) += accessibility/ |
| | 124 | obj-$(CONFIG_ISDN) += isdn/ |
| | 125 | obj-$(CONFIG_EDAC) += edac/ |
| | 126 | obj-$(CONFIG_EISA) += eisa/ |
| | 127 | obj-$(CONFIG_PM_OPP) += opp/ |
| | 128 | obj-$(CONFIG_CPU_FREQ) += cpufreq/ |
| | 129 | obj-$(CONFIG_CPU_IDLE) += cpuidle/ |
| | 130 | obj-y += mmc/ |
| | 131 | obj-y += ufs/ |
| | 132 | obj-$(CONFIG_MEMSTICK) += memstick/ |
| | 133 | obj-y += leds/ |
| | 134 | obj-$(CONFIG_INFINIBAND) += infiniband/ |
| | 135 | obj-y += firmware/ |
| | 136 | obj-$(CONFIG_CRYPTO) += crypto/ |
| | 137 | obj-$(CONFIG_SUPERH) += sh/ |
| | 138 | obj-y += clocksource/ |
| | 139 | obj-$(CONFIG_DCA) += dca/ |
| | 140 | obj-$(CONFIG_HID_SUPPORT) += hid/ |
| | 141 | obj-$(CONFIG_PPC_PS3) += ps3/ |
| | 142 | obj-$(CONFIG_OF) += of/ |
| | 143 | obj-$(CONFIG_SSB) += ssb/ |
| | 144 | obj-$(CONFIG_BCMA) += bcma/ |
| | 145 | obj-$(CONFIG_VHOST_RING) += vhost/ |
| | 146 | obj-$(CONFIG_VHOST_IOTLB) += vhost/ |
| | 147 | obj-$(CONFIG_VHOST) += vhost/ |
| | 148 | obj-$(CONFIG_GREYBUS) += greybus/ |
| | 149 | obj-$(CONFIG_COMEDI) += comedi/ |
| | 150 | obj-$(CONFIG_STAGING) += staging/ |
| | 151 | obj-y += platform/ |
| | 152 | |
| | 153 | obj-$(CONFIG_MAILBOX) += mailbox/ |
| | 154 | obj-$(CONFIG_HWSPINLOCK) += hwspinlock/ |
| | 155 | obj-$(CONFIG_REMOTEPROC) += remoteproc/ |
| | 156 | obj-$(CONFIG_RPMSG) += rpmsg/ |
| | 157 | obj-$(CONFIG_SOUNDWIRE) += soundwire/ |
| | 158 | |
| | 159 | # Virtualization drivers |
| | 160 | obj-$(CONFIG_VIRT_DRIVERS) += virt/ |
| | 161 | obj-$(subst m,y,$(CONFIG_HYPERV)) += hv/ |
| | 162 | |
| | 163 | obj-$(CONFIG_PM_DEVFREQ) += devfreq/ |
| | 164 | obj-$(CONFIG_EXTCON) += extcon/ |
| | 165 | obj-$(CONFIG_MEMORY) += memory/ |
| | 166 | obj-$(CONFIG_IIO) += iio/ |
| | 167 | obj-$(CONFIG_IPACK_BUS) += ipack/ |
| | 168 | obj-$(CONFIG_NTB) += ntb/ |
| | 169 | obj-$(CONFIG_POWERCAP) += powercap/ |
| | 170 | obj-$(CONFIG_MCB) += mcb/ |
| | 171 | obj-$(CONFIG_PERF_EVENTS) += perf/ |
| | 172 | obj-$(CONFIG_RAS) += ras/ |
| | 173 | obj-$(CONFIG_USB4) += thunderbolt/ |
| | 174 | obj-$(CONFIG_CORESIGHT) += hwtracing/coresight/ |
| | 175 | obj-y += hwtracing/intel_th/ |
| | 176 | obj-$(CONFIG_STM) += hwtracing/stm/ |
| | 177 | obj-$(CONFIG_HISI_PTT) += hwtracing/ptt/ |
| | 178 | obj-y += android/ |
| | 179 | obj-$(CONFIG_NVMEM) += nvmem/ |
| | 180 | obj-$(CONFIG_FPGA) += fpga/ |
| | 181 | obj-$(CONFIG_FSI) += fsi/ |
| | 182 | obj-$(CONFIG_TEE) += tee/ |
| | 183 | obj-$(CONFIG_MULTIPLEXER) += mux/ |
| | 184 | obj-$(CONFIG_SIOX) += siox/ |
| | 185 | obj-$(CONFIG_GNSS) += gnss/ |
| | 186 | obj-$(CONFIG_INTERCONNECT) += interconnect/ |
| | 187 | obj-$(CONFIG_COUNTER) += counter/ |
| | 188 | obj-$(CONFIG_MOST) += most/ |
| | 189 | obj-$(CONFIG_PECI) += peci/ |
| | 190 | obj-$(CONFIG_HTE) += hte/ |
| | 191 | obj-$(CONFIG_DRM_ACCEL) += accel/ |
| | 192 | obj-$(CONFIG_CDX_BUS) += cdx/ |
| | 193 | obj-$(CONFIG_DPLL) += dpll/ |
| | 194 | |
| | 195 | obj-$(CONFIG_S390) += s390/ |
projects / linux-2.6-block.git / blame_incremental