Commit | Line | Data |
---|---|---|
6f52b16c | 1 | /* SPDX-License-Identifier: GPL-2.0 WITH Linux-syscall-note */ |
607ca46e DH |
2 | /* $Id: scc.h,v 1.29 1997/04/02 14:56:45 jreuter Exp jreuter $ */ |
3 | ||
4 | #ifndef _UAPI_SCC_H | |
5 | #define _UAPI_SCC_H | |
6 | ||
7 | ||
8 | /* selection of hardware types */ | |
9 | ||
10 | #define PA0HZP 0x00 /* hardware type for PA0HZP SCC card and compatible */ | |
11 | #define EAGLE 0x01 /* hardware type for EAGLE card */ | |
12 | #define PC100 0x02 /* hardware type for PC100 card */ | |
13 | #define PRIMUS 0x04 /* hardware type for PRIMUS-PC (DG9BL) card */ | |
14 | #define DRSI 0x08 /* hardware type for DRSI PC*Packet card */ | |
15 | #define BAYCOM 0x10 /* hardware type for BayCom (U)SCC */ | |
16 | ||
17 | /* DEV ioctl() commands */ | |
18 | ||
19 | enum SCC_ioctl_cmds { | |
20 | SIOCSCCRESERVED = SIOCDEVPRIVATE, | |
21 | SIOCSCCCFG, | |
22 | SIOCSCCINI, | |
23 | SIOCSCCCHANINI, | |
24 | SIOCSCCSMEM, | |
25 | SIOCSCCGKISS, | |
26 | SIOCSCCSKISS, | |
27 | SIOCSCCGSTAT, | |
28 | SIOCSCCCAL | |
29 | }; | |
30 | ||
31 | /* Device parameter control (from WAMPES) */ | |
32 | ||
33 | enum L1_params { | |
34 | PARAM_DATA, | |
35 | PARAM_TXDELAY, | |
36 | PARAM_PERSIST, | |
37 | PARAM_SLOTTIME, | |
38 | PARAM_TXTAIL, | |
39 | PARAM_FULLDUP, | |
40 | PARAM_SOFTDCD, /* was: PARAM_HW */ | |
41 | PARAM_MUTE, /* ??? */ | |
42 | PARAM_DTR, | |
43 | PARAM_RTS, | |
44 | PARAM_SPEED, | |
45 | PARAM_ENDDELAY, /* ??? */ | |
46 | PARAM_GROUP, | |
47 | PARAM_IDLE, | |
48 | PARAM_MIN, | |
49 | PARAM_MAXKEY, | |
50 | PARAM_WAIT, | |
51 | PARAM_MAXDEFER, | |
52 | PARAM_TX, | |
53 | PARAM_HWEVENT = 31, | |
54 | PARAM_RETURN = 255 /* reset kiss mode */ | |
55 | }; | |
56 | ||
57 | /* fulldup parameter */ | |
58 | ||
59 | enum FULLDUP_modes { | |
60 | KISS_DUPLEX_HALF, /* normal CSMA operation */ | |
61 | KISS_DUPLEX_FULL, /* fullduplex, key down trx after transmission */ | |
62 | KISS_DUPLEX_LINK, /* fullduplex, key down trx after 'idletime' sec */ | |
63 | KISS_DUPLEX_OPTIMA /* fullduplex, let the protocol layer control the hw */ | |
64 | }; | |
65 | ||
66 | /* misc. parameters */ | |
67 | ||
68 | #define TIMER_OFF 65535U /* to switch off timers */ | |
69 | #define NO_SUCH_PARAM 65534U /* param not implemented */ | |
70 | ||
71 | /* HWEVENT parameter */ | |
72 | ||
73 | enum HWEVENT_opts { | |
74 | HWEV_DCD_ON, | |
75 | HWEV_DCD_OFF, | |
76 | HWEV_ALL_SENT | |
77 | }; | |
78 | ||
79 | /* channel grouping */ | |
80 | ||
81 | #define RXGROUP 0100 /* if set, only tx when all channels clear */ | |
82 | #define TXGROUP 0200 /* if set, don't transmit simultaneously */ | |
83 | ||
84 | /* Tx/Rx clock sources */ | |
85 | ||
86 | enum CLOCK_sources { | |
87 | CLK_DPLL, /* normal halfduplex operation */ | |
88 | CLK_EXTERNAL, /* external clocking (G3RUH/DF9IC modems) */ | |
89 | CLK_DIVIDER, /* Rx = DPLL, Tx = divider (fullduplex with */ | |
90 | /* modems without clock regeneration */ | |
91 | CLK_BRG /* experimental fullduplex mode with DPLL/BRG for */ | |
92 | /* MODEMs without clock recovery */ | |
93 | }; | |
94 | ||
95 | /* Tx state */ | |
96 | ||
97 | enum TX_state { | |
98 | TXS_IDLE, /* Transmitter off, no data pending */ | |
99 | TXS_BUSY, /* waiting for permission to send / tailtime */ | |
100 | TXS_ACTIVE, /* Transmitter on, sending data */ | |
101 | TXS_NEWFRAME, /* reset CRC and send (next) frame */ | |
102 | TXS_IDLE2, /* Transmitter on, no data pending */ | |
103 | TXS_WAIT, /* Waiting for Mintime to expire */ | |
104 | TXS_TIMEOUT /* We had a transmission timeout */ | |
105 | }; | |
106 | ||
107 | typedef unsigned long io_port; /* type definition for an 'io port address' */ | |
108 | ||
109 | /* SCC statistical information */ | |
110 | ||
111 | struct scc_stat { | |
112 | long rxints; /* Receiver interrupts */ | |
113 | long txints; /* Transmitter interrupts */ | |
114 | long exints; /* External/status interrupts */ | |
115 | long spints; /* Special receiver interrupts */ | |
116 | ||
117 | long txframes; /* Packets sent */ | |
118 | long rxframes; /* Number of Frames Actually Received */ | |
119 | long rxerrs; /* CRC Errors */ | |
120 | long txerrs; /* KISS errors */ | |
121 | ||
122 | unsigned int nospace; /* "Out of buffers" */ | |
123 | unsigned int rx_over; /* Receiver Overruns */ | |
124 | unsigned int tx_under; /* Transmitter Underruns */ | |
125 | ||
126 | unsigned int tx_state; /* Transmitter state */ | |
127 | int tx_queued; /* tx frames enqueued */ | |
128 | ||
129 | unsigned int maxqueue; /* allocated tx_buffers */ | |
130 | unsigned int bufsize; /* used buffersize */ | |
131 | }; | |
132 | ||
133 | struct scc_modem { | |
134 | long speed; /* Line speed, bps */ | |
135 | char clocksrc; /* 0 = DPLL, 1 = external, 2 = divider */ | |
136 | char nrz; /* NRZ instead of NRZI */ | |
137 | }; | |
138 | ||
139 | struct scc_kiss_cmd { | |
140 | int command; /* one of the KISS-Commands defined above */ | |
141 | unsigned param; /* KISS-Param */ | |
142 | }; | |
143 | ||
144 | struct scc_hw_config { | |
145 | io_port data_a; /* data port channel A */ | |
146 | io_port ctrl_a; /* control port channel A */ | |
147 | io_port data_b; /* data port channel B */ | |
148 | io_port ctrl_b; /* control port channel B */ | |
149 | io_port vector_latch; /* INTACK-Latch (#) */ | |
150 | io_port special; /* special function port */ | |
151 | ||
152 | int irq; /* irq */ | |
153 | long clock; /* clock */ | |
154 | char option; /* command for function port */ | |
155 | ||
156 | char brand; /* hardware type */ | |
157 | char escc; /* use ext. features of a 8580/85180/85280 */ | |
158 | }; | |
159 | ||
160 | /* (#) only one INTACK latch allowed. */ | |
161 | ||
162 | ||
163 | struct scc_mem_config { | |
164 | unsigned int dummy; | |
165 | unsigned int bufsize; | |
166 | }; | |
167 | ||
168 | struct scc_calibrate { | |
169 | unsigned int time; | |
170 | unsigned char pattern; | |
171 | }; | |
172 | ||
173 | #endif /* _UAPI_SCC_H */ |