firmware: arm_scmi: Add basic support for SCMI v3.2 pincontrol protocol

[linux-2.6-block.git] / drivers / firmware / arm_scmi / Makefile

# SPDX-License-Identifier: GPL-2.0-only
scmi-bus-y = bus.o
scmi-core-objs := $(scmi-bus-y)

scmi-driver-y = driver.o notify.o
scmi-driver-$(CONFIG_ARM_SCMI_RAW_MODE_SUPPORT) += raw_mode.o
scmi-transport-$(CONFIG_ARM_SCMI_HAVE_SHMEM) = shmem.o
scmi-transport-$(CONFIG_ARM_SCMI_TRANSPORT_MAILBOX) += mailbox.o
scmi-transport-$(CONFIG_ARM_SCMI_TRANSPORT_SMC) += smc.o
scmi-transport-$(CONFIG_ARM_SCMI_HAVE_MSG) += msg.o
scmi-transport-$(CONFIG_ARM_SCMI_TRANSPORT_VIRTIO) += virtio.o
scmi-transport-$(CONFIG_ARM_SCMI_TRANSPORT_OPTEE) += optee.o
scmi-protocols-y := base.o clock.o perf.o power.o reset.o sensors.o system.o voltage.o powercap.o
scmi-protocols-y += pinctrl.o
scmi-module-objs := $(scmi-driver-y) $(scmi-protocols-y) $(scmi-transport-y)

obj-$(CONFIG_ARM_SCMI_PROTOCOL) += scmi-core.o
obj-$(CONFIG_ARM_SCMI_PROTOCOL) += scmi-module.o

obj-$(CONFIG_ARM_SCMI_POWER_CONTROL) += scmi_power_control.o

ifeq ($(CONFIG_THUMB2_KERNEL)$(CONFIG_CC_IS_CLANG),yy)
# The use of R7 in the SMCCC conflicts with the compiler's use of R7 as a frame
# pointer in Thumb2 mode, which is forcibly enabled by Clang when profiling
# hooks are inserted via the -pg switch.
CFLAGS_REMOVE_smc.o += $(CC_FLAGS_FTRACE)
endif